Other Network Architecture Subjects

I have a configuration with two WAN routers connecting to a BGP cloud. These two routes connnect to a 6500 on the inside. I want one router to be primary for inbound and outbound traffic. We are redistributing BGP into EIGRP. Under EIGRP we have:!Pri...

i have configured a dmvpn hub and spoke. Is there and additional configuration after the tunnel has been setup? I bilieve the hub and spoke are connected, but the hub cannot ping the spoke and vise versa.ThanksRN

I have a strange problem. I have a 7513 that has one static default route. This route is being redistributed into EIGRP.The 7513 advertises this route along with the native EIGRP routes to 60 remote sites. The remote site router are 3640s. All config...

This question has been posted before by gbrillard but it doesn't look like there was an answer.Is it possible to use the default telnet session (port 23) in Config Management ==> Config Job Setup in order to fetch configs from ie CatOS devices and a...

Hello ,We are going to upgrade our Production Network with 6509's as Core Switches with MSFC2 card ( 2 X 6509 for Redundancy & Load balancing ) .We have ordered each 6509 with Redundant sup engine .We will configure HSRP .What is the best Routing ...

I have a question reguarding BGP aggregate routes and more specific routes. Currently we have 2 WAN links w/ large carriers running eBGP, we advertise our /19 aggregate, example 192.168.0.0/19.A customer of ours, who's range is say 192.168.16.0/24 w...

I have a 7204 with a T3 (PA)module. I would like to take 3 T1s from the T3 and map them to a 4 port (PA) T1 module. Does anyone happen to have any documentation on how to configure this?

Hi,I am building a lab for Cisco lab at my school.I will need racks for putting 11 Cisco routers( 2500, 1760, 2600) and 3 switches(2950). Also for some servers (IBM x305). And ofcourse I will need some wire rack( the ladder) for running cable on the ...

Hello all,I have a switch running some new modules (Sup720, WS-6724-SFP). When trying to view the switch via CiscoView, those new modules are displayed as unsupported.According to the documentation, the switch is running a supported CatOS version. Th...

Hello,We have a main site and a branch that are connected as follows:Cisco 1600--CSU/DSU--T1--CSU/DSU--Cisco 1600.The CSU/DSUs have voice and data.Voice is O.K however data is not, no errors detected on the CSU/DSU or the reouter Links are up on both...

I get these messages which I have looked up on the Cisco site and have identifed the sources. I have also done a Data Capture and found out that it is the default gateway (MSFC) on one of the affected servers that is sending to the MAC Address as a d...

I have a VWIC T1 card in my router for connection to the PSTN. However, when I go into configuration mode to set up my T1 controller I don't see PRI-Group as an option. I only have the channel-group option which I thought was for data access. I ha...

During a conversion from hybrid to native mode the config-register of the RP and SP need to be changed so the RP and SP bootup in ROMMON. Once a reset or reload has been entered and the ROMMON cli is showing, how do you tell if you are in ROMMON mo...