I am a real newbie to Ciscoworks, and I am wondering where to find the device updates for CiscoView when you receive a "Unsupported Card." Please Advice.
Is MD5 authentication in BGP authenticates all types of BGP message, including KEEPALIVE, OPEN? If yes, does it mean that BGP will put the link in down status if the remote router do not have the password set correctly? Thanks
Hi we recently bought a 6513 chassis and we are having some problems with it. It keeps dropping everyone off the network. The Log shows the following enteries. Can anyone help..12:01:40: %PM_SCP-SP-6-LCP_FW_ERR_INFORM: Module 6 is experiencing the fo...
I have a 1760 with an ADSL WIC that I am trying to connect to the Internet (via SBC). They provided a DSL modem but we would rather use the router, using a config I feel 99.99% is correct, every 4 minutes or so, I get the following console message:(D...
This would seem to be a simple question, but it's got me stumped.I have a rogue host on my network. It is sourcing packets apparently from an IP address that is off net: 5.0.3.0. Amongst other things, it is trying to NTP peer with the router, but t...
I have a single 2948G-L3 which routes between 2 additional catalyst 2900XL (24 port) switches in one wing of a building. The 2948G-L3 has four BVIs configured for 4 subnets and there are vlans set up as appropriate on the 2900XL catalysts attached t...
Can someone helpw me with a 8510 configuration issue? I have an issue where pkts are being dropped when attempting to send large number of packets over a single PVC. I have configured a bridge group 28 (subif: 4/0/0.28) to bridge 1483 Bridged over AT...
Hi,Has anybody had any chance to use/deploy emulation cards? I am using it in my design and will test very soon. I just want to know if anybody had any experince with it?ThanksRegardsFE
DELL 3024 with GBIC will not linkup to a Cisco3750GSwitch with SFP. Will not link to Cisco2950G GBIC either.Anyone seen this?DELL - DELL O.K over Fibre.Cisco - Cisco O.K. over same Fibre.Thanks,Bob
I have Cisco 2522 router. I have configured it to connect with ISDN bri for internet sharing with NAT enabled. For my clients machine to reslove internet domain names i have installed a windows DNS Server in my LAN which is forwarding to queries to I...
What is the best way to accomplish this scenario:I have a 4506 switch with Sup II+ engine. I will connect via ethernet to a 1721 router that will provide my internet traffic, and a point to point link to a remote site. In case of an outage on the P2...
Brothers i want to know that when we are using frame-relay with sub interfaces. So we use point-to-point and multipoint parameters. Pls tell me what is the difference between those . Advantages and disadvantages of both in real senerio. Pls provide e...
Hello,We plane to acquire 1760 routers, but i have some questions about the possibility to have the VWIC-1MFT-G703 pluged into a VIC slot of a 1760 router (the WAN slots are full).I know that it possible but is it possible to have wan data functions...
I am having a 2611XM router with 1-port ISDN BRI NT-1 interface card. I am facing problems with ISDN connectivity. Kindly see the connfiguration below for reference:version 12.3service timestamps debug datetime msecservice timestamps log datetime m...
