Other Network Architecture Subjects

Please how do I show the passive interfaces in the following network based on Advanced EIGRP Named Configuration Approach, apart from using the "show run" command. When I set up the network using the Basic EIGRP configuration and issue the "show ip p...

Good Day! May I ask which 10gb sfp is compatible with our cisco switch 2960x series switch ws-c2960-24TS-L Thank you very much June Charanguero

We have an ASA 5550 on DC Power.  The manufacturers label on this unit recommends a 2.5 amp fuse.  We have had a 3 amp installed actually but it has blown out twice since Nov '16.   However two documents I have found on these units seem to imply 10-1...

Is there a way to see a forgotten pin number for voicemail or to reset without the number?

We have Cisco ISE 2.0, which we are using for Wireless authentication using Active directory. We are looking to implement tacas+ authentication for our Network devices as well, but we dont want to use AD which is used for Wireless. I could see we ha...

We have a number of remote sites connecting to headends via IPSec encrypted GRE tunnels over the public internet. Our current configuration works, but we would like to see if there is a better way of handling the no-split tunnel rule. At the headend...

Hi. I have a weird generalized, I guess, question that is about to drive me mad. I've got a Lenovo T420 that will connect to a wifi hotspot through cell phones but will not connect to our company's wifi (which I do have admin rights to). It sees our ...

I have a WS-C3850-48U IOS version 03.03.03SE, that's triggering temp sensor alerts in our monitoring system. See the below output from the switch:  #show environment temperature statInlet Temperature Value: 24 Degree CelsiusTemperature State: GREENY...

I need to add  One10G line cards contains 4 10G ports to the below Chassis , should I upgrade the Sup also and what is the recommended SUP Model if needed. Mod Ports Card Type Model Serial No.--- ----- -------------------------------------- -------...

Can anyone tell me the difference in throughput between a bonded T1 (4x) solution (6 Mb/s bandwidth) and a single 6 Mb/s fiber solution.  How could I possibly measure this?

We are a supplier of security appliances to customers and we have traditionally just supplied a server A new product we are working on will also deliver cisco switches as well as the server On the HP website there is the option of registering all the...

Hi guys, I am having an issue with incoming traffic from some ISPs. Any help be greatly appreciated. Please see topology below.   Default route is coming in from both ISPs for outbound traffic. As shown in diagram, i am advertising full range from ...