Other Network Architecture Subjects

hey just wondering is there any way to put a SNMP trap for warmstarts on to 2924 switch for the image c2900xl-c3h2s-mz.120-5.WC8.bin. I know its available for 2950 switch's, the command on 2950 is as follow, but 2924 doesnt support the warmstartsnmp-...

What does it mean when the response I get to the write mem command is:cutdowncutdowncutdown.This is occurring on my 7206 router. Never encountered this response before.tiaTV

I have a cisco catalyst 3548 xl and a cisco catalyst 1900 switch. Can I use either of those switches to subnet my lan network?

And I wanna know if the S733ZK9-12217SX can surpport Reflexive ACL.

Initial install, unable to receive either transmit or receive indicator after booting up. Configuration is from a know working 827H except for username and password. Would you receive the indications upon attempting to contact vendor’s end? Even th...

I have a truetime NTP server on the network and I point to it with several routers. When I do a show ntp associations detail and sh ntp status, I get stratum information indicating that the truetime is at stratum 1 and the router pointing to it is a...

Hello,I have an ethernet network constitued with two 3550 as backbone switches and a number of 2950 as access switches . The network is running IP but i have to connect an IBM AS 400 running SNA . I have vo idea on how to configure my switches to h...

I have a LMS 2.2 and a ITM 2.0 stations.On ITM, I installed the latest IDU 2.0.On LMS, I installed the RMEsynchronization moduleto let ITM synchronize with the RME inventory of LMS.During the installation of this module, you need toput a username/pas...

does the catalyst 4006 supports sup 4 (WS-X4515=) ?

Folks, I am very new to Cisco works campus manager.I am unable to register cisco devices to my Ciscoworks server. Any help would be apprecieted, i defined the snmp string on the ciscoworks server and also the IOS switch.snmp-server engineID ...

I'm curious why the following occurs.interface e0 172.16.4.1/21serial s0 172.16.20.1/29conf trouter ospf 1 network 172.16.4.0 0.0.7.255 area 0 network 172.16.20.0 0.0.0.7 area 0show runrouter ospf 1 network 172.16.0.0 0.0.7.255 area 0 network 172.16....

3725 with 4pt IMA i/f connected to ISP. Internet DNS is provided by ISP.DNS will slowly stop responding until a reboot is needed in order.Any help appreciated.

I have been noticing this for sometime and it does not seem to be causing much of a problem to the connectivity, but I would like to prevent any problems. In the output below of the serial interface, the input queue shows: Input queue: 0/75/94249/0 ...

My cache engine has crashed. Then to solve the problem I've downloaded one copy of te cache engine 505 image(ce505.bin) But after reinstalling (successfully) the cache i'm always requested for a username and password but the old cache username and pa...

HiDuring boot of 1760 router it is giving error message sayingBad RAM at location 0x00000000:Wrote 0x55555555, read 0x55515550It is stuck up on this screen and not allowing router to boot.Suggest the solution.RegdsSanjay Kapoor