Other Network Architecture Subjects

Good day. I hope to ask one of my problem. I want to show live traffic in Cisco 7609-S, but I cannot find any proper command for this problem. I already know some command in XR 'monitor interface ~' but in 7609 it's seem not support this command. A...

OK I have a IR809G-LTE-VZ-K9 configured with the below configuration and it works fine until I plug into the G0 or G1 interface. Once I plugin the cellular 0 interface will not stay up. It just keeps going up and down, but once I unplug from the inte...

Hello, I am looking for the hazardous location certification file numbers from UL/CSA for the following products: - IE3000 series industrial networking switches - PWR-IE50W-AC - power supply for IE3000 series equipment Any help, even a direction of w...

ObjectalSslStatsActiveSessionsOID1.3.6.1.4.1.3076.2.1.2.26.1.2TypeGaugePermissionread-onlyStatusmandatoryMIB ALTIGA-SSL-STATS-MIB-V1SMI ;   -   View Supporting Images DescriptionThe current number of active sessions. Hello, The results given by...

Hello to all, I bought a brand new Cisco 897 sealed from ebay.Unfortunately the console port it doesnt work.I am trying to find an email to contact cisco (in Ireland) so I can ask them about the cost of fixing it but I cant find it somewhere.Is this...

Outside of the numerous books and video we have on the Cisco site. Does anyone have a Cheat Sheet on setting up a Cisco ACE 4710?  I've been tasked to power up our ACE and come find out it's not under support nor the latest code. It's running A5(1.2)...

Want the setup to be in such away that the router will be doing:NAT, inside might be 10.1.1.1/24 and outside will be IP issued by ISP - 202.62.x.xRouter to also act as a DHCP server issuing out IP to a workshop participants.Do you have a template/doc...

Hello Guys  Please, could you give a help. I have some problems when i go sub-interface FastEthernet0.0 to set up Router Inter-VLAN Routing I dont find this option  : encapsulation dot1q vlan-id native inside sub-interface. My router is Cisco 877 . ...

Dear all, What if site where Cisco IWAN's HUB MC is power down or entire that location down ? how can we provide redundancy when Hub site fails ?

Hi,for obvious reasons the protection of NTP servers exposed to the Internet is currently getting some reinvestigation. On a fresh 4500-X running IOS-XE 03.04.03.SG (aka 151-2.SG3) I encountered thataccess-list 12 permit x.y.z.123access-list 12 permi...

Dear Team, Please help me to understand can Cisco ASR 1002 X can work on single AC power supply unit. Is it mandatory to provide AC power for both the AC power supplies.   

There are three sites A, B and C, the OTV link between site A and B is currently in operation, this works correctly, interface Overlay 1. If you want to add site C, you already have a connection to sites A and B, when you configure OTV between site C...

Hello,   I am new to this forum. My question may have already ask and possible answered. If so, can someone can point to the reference.  I would like to use CCP to managed my CISCO devises, however I use a mac. CISCO website states the requirement to...

Is the OSI model applicable for Smart Homes?  If so, can you recommend some websites to research this information?