Other Network Architecture Subjects

can someone clarify this, as far i haven't been able to get a firm answer.clockrate sets the link speed, while bandwidth sets a metric calculation variable?for the longest time i've been told bandwidth sets the linkspeed, but now i've been told other...

Hi,I want to configure a Cisco 803 so that it is possible to dial-in into our network, after login the dial-in PC[192.168.2.2] is connected to the ISDN-Interface[192.168.2.1] of the router and it is possible to reach the Ethernet-Interface[192.168.1....

I am trying to configure a route map on a 4232-L3 routing module at code level 12.0(10)W5(18f). I know this is several revs behind but need to get the route map working asap. I am going to proceed with the code upgrade but does anyone know if this m...

We want to migrate several Gigabitlinks over a DWDM Solution , the problem is.If the DWDM switch over to the Backup Darkfiber the DWDM switch of the light for 50 ms to the Cisco Switch , the result is a link down on the Switchport.so, how long can be...

Our customer was having the following setup- core switch 6500 with 5 vlans (1,2,3,4,5)- protocol used is ospf- servers and some power users are on vlan 1findings;- users on vlan 1 can login to the servers with acceptable response time.- users on the ...

I have a problem It sounds not logical, the problem is I am not able to ping to the server, but i can get an ip address from the server, and this problem is not for long time after few hours it starts pinging to the server, Could any one help me to r...

Hello,I do have a problem getting my ONT to talk to my ESSE on Layer 2. I am using a Catalyst 6506 connected with A Gigabit to a Catalyst 4507. The trunk is configured for dot1q and my VLAN for the ESSE and ONT is VLAN 64. My native vlan is 1. The ES...

how to config 2 64k customer on a singel isdn line,ie to make use of the 1st B channel for one customer & 2nd B channel for another customerI think this is the config , but some minor error are there, any light on this interface BRI 1/0 ip unnumbered...

Hello all,I am trying to get the gui (front and back images) up for a 2950 switch using ciscoview. Community strings are set correctly, but I receive the following error:Can't find application device package for 192.268.1.2Probable Cause:Device pack...

I have a catalyst 2800 that was previously configured, I need to access the management console but I have no idea how to do this, there is no port marked "console", and I have a RS-232 port on the back and a 25 pin AUI and 25 ethernet ports on the fr...

How can I desable DNS (A&PTR) translation?DNS (A&PTR) translation dont necessary for me because that dont support zone transfer translation.Thanks.

Hello,Support one Cisco6509 and Cisco6006 the same unicast Mac in multiples ports?.Regards.

Can 2600 router be used to terminate T1 frame connection. I was wondering if I can split these channels .. 16 channels on frame and 8 to go directly to internet. I know we can split a channelized T1 between PRI (voice) and T1 for data. But not su...

Durring an upgrade from 5.4(2) to 7.6(3a), one of our 6509's halted booting from bootlfash and switched to slot0, continued to boot from slot0. No lie, I perfomed this upgrade to twelve switches in a row without error, this was the first switch that ...