I have a plane cisco catalyst 3524 xl and I need to connect ten PC two of which on a separate vlan but the switch only lets me enable one vlan at time.Can anybody help me figure out the steps I need to go through to make this simple lan work?thanks
Can anybody explain me about the implementacin of the cisco express forwarding( CEF)?? I need to configure a load sharing in my cisco 7513 router. I have 2 E1 connections, and my proposite is to have an equal load sharing with the 2 connections. We d...
We have a Sup1a-2ge, with 64mb ram. We need to upgrade to be able to use the newer versions of code. I've seen on the Cisco site,that there is an upgrade kit to upgrade the MSFC to 128mb ram. If you have the Sup1a-msfc, it is not field upgradable. Si...
Hello,When monitoring a Catalyst 6500 temperature, which temperature in the show env temp has to be monitored?Is it enough to monitor just one of them?Or shall I monitor all the outputs?Thanks in advance for any reply.Alex
Hi,Could someone tell me what the RCAPI directory number assigned by the ISDN provider is as I have contacted my ISDN provider and they know nothing about it. I am trying to setup a connection for OFTP (Odex FTP) using X25 over isdn and using a cisc...
Guys,i want to script the export of all my devices from me rme 3.4/5 database and copy this to a backup dir .,.i can import from CLI CRMimport.pl ...but is there a command to export from the CLI...i can find no mention of 1 many thankssteve
Hi,the soho97 ADSL router has 4 ports on the back, but only displays one interface in the IOS (e0). Is it possible to assign ip addresses to each of the individual ports. I'm not wanting to use DHCP. any help would be grateful.cheers,Steve.
I have a client who has the following setup. network_1 (10.166.53.0) on this network is a 1601-R with a T1 for internet. behind that 1601 is a firewall (10.166.53.101). Everyone on network_1 sees internet fine. They also have 2 1601-R's that are set...
I experience Problems with our Cat 6509. CPU Peak is 4 % so the Switch has nothing to do on its backplane. 2HP PC´s Connected to the 6348 Module in Slot 5 ( port 9 and 10) can only transfer from 800K to 5 MB per Second. messured with NetIO. Connectin...
While capturing packets on our Cat 4006 (Sup III/IOS) switch, I noticed that I am receiving frames for other unicast hosts that belong to my VLAN.The destination MAC addresses are known by the switch, and are mostly out it's int port-channel1 (connec...
I have an existing NAT setup using"ip nat inside source list <x> interface <Outside IF> overload"and"ip nat outside source static <OutAddr> <InAddr>"for outbound traffic, to:1)Translate all inside source addresses to the outside interface address2)St...
Hi,On Cisco's Website there are two versions available for Cisco 3550 EMI12.1.19EA1c (released Feb 19)12.1.20EA1 (released Feb 10)How can a newer release version (12.1.20) can get released "before (on Feb 10)" an older version (12.1.19) ?If i plan t...
