Other Network Architecture Subjects

I am wanting to see if there is any infomation available for setting up ppoe on a 2514 router running the newest IOS. I have heard this can be done but i cannot find much documentation on it. Any help with this would be greatly appriciated.Adam Howar...

I would like to know What command use to set up a port to transport Jumbo/Giant frames? is there any limitation regards type of module (Fast Eth or Gig Eth)? What is the maximum frame size allowed?Thanks,Gilson

Hi Guys,I have a problem at a customer site which is troubling me and I can't figure it out (allthough I have quite some experience on Catalyst switches). So, Im hoping that someone on this forum can help me out with usefull tips or ideas.Here's the ...

Hello,I would like to have more than one tacacs-server host commands in my config.I'm wondering how the router will parse the server - in a round-robin fashion, it will go to the next server only if the first one is out of service and so on ... so fa...

We have a 3745 with 1 x VWIC-2MFT-T1, both are connected to the PSTN via PRI in voice mode (mgcp gateway to call manager). We also have a NM-24DM module in the router. Currently the contollers/serials interface are set for time slots 1-24, with one D...

I use LRE switch with cpe 575.I use the following configuration on LRE switchinterface LongReachEthernet0/1 description *** Port to CPE*** switchport access vlan 2 bandwidth 4096 no ip address load-interval 30 cpe type CISCO575-LRE profile LRE-4I tes...

I recently joined an organisation and started to monitor the network. I soon found that one of the routers had an average utilization of around 50% and often peaked into the high 90's. To confirm this I checked the router with a sh processes cpu wh...

Hi there,I am in need of serial numbers for all my cisco network devices. When I telneting to the switches and entering show version command I am getting the serial number where as the same when I am entering in the routers I didn't get it. I have ...

I would like to configura the above router with 1483 bridging. The pc is using a software to connect. How can I configure the router. I have used before the pppoE and worked fine. Using 1483 bridging with dynamic ip how can I do that?thanx

Hi,How to create spantree loop in a lab using cat 6509, cat 4006 or any other switches.What is the basic BPDU guard & loop guard configuration for preventing it.RegardsM

I have a 4234 Layer 3 blade installed in a 4006 switch w/ a Sup.II at my client. The router blade is currently running 12.0(14)W5(20) code.I looked at code 12.3, 12.2, 12.1 AND 12.0 on the IOS upgrade planner, but did not even see the model listed.W...

We're running LMS 2.1 to monitor the Cat-2980G's, Cat-2950's and Cat-6506's switches. We need to change the SNMP passwords in all the configs. Does anybody happens to know if there's a way in LMS to push that change to all the switches?Thanks.

I have a few 2621's (over 50!)using an AIM-VPN/EP, or least I think they are using EP. A few of them maybe using AIM-VPN/BPIs there a way RME can verify what is actually installed.detailed hardware report just says "aim-encryption Virtual Private Net...

All my devices in Ciscoworks have discovered by IP Address and not name, i have added all the devices into the relevant Zones on a DNS server and my Ciscoworks Windows server is now using that DNS as its secondary DNS server, shouldnt it be able to r...