Other Network Architecture Subjects

I was wanting to get ya'lls opinions on this and see if ya'll think it might work.Basically I have two locations (Amarillo and Chicago) that I want to connect together using VPN and OSPF (loadsharing). Each location will have two internet T1's comin...

Hi, 1.If I nat 172.16.2.5 to x.x.x.x public ip.will I be able to ping and trace from a public machine to 172.16.2.5. 2.That is will my trace results show reachability till the public interface and drop from their or will it reach the specific ip (17...

Hi1-What is the difference between subnet and vlan? 2- In vlan does i make servers in one vlan and PCs in other vlans and how ?

Please help.I need to program the router to direct all requests for onen ip address to a different router.ie. all to the 837 router (10.10.10.1) for internet, accept 172.16.1.1 which needs to be directed through another router(10.10.10.100)Thanks for...

This applies to the previous question about blocking DHCP requests/traffic across a Cisco 2611xm router.HELP!!!! I just applied the ACL to the two FE interfaces and I've lost my connection to the router and can't get back in!!What I did was:1) In int...

I have two blocks of IPS and two subnetmask's64.132.148.48/28usable 64.132.148.49 <-> 64.132.148.62netmask 255.255.255.240second set64.132.148.64/27usable 64.132.148.65 <-> 64.132.148.94netmask 255.255.255.224In my route e/0 what netmask shuold I be ...

Hi,Want to know the amount of RAM on my router 3660. Did show version and saw:cisco 3660 (R527x) processor (revision 1.0) with 118784K/12288K bytes of memory.Is this the amount of RAM? And what is the difference between the figure before and after t...

Hi all,is it possible to log NAT translations and DHCP bindingsto a syslog server ? I have a Cat6k/MSFC2 with IOS 12.1acting like a DHCP server and doing NAT. I found no wayso far.. ?ThanksRalf

We have two Cat4506 configured also for dhcp.After changing the time to the current one the output from show runnning command, after a long wait, is truncated and only the dhcp configuration do not show up. Also when we issue the "show ip dhcp bindin...

hello,is there any problem if the vlan IDs connecting 2 switches with multiple VLAN differs..say vlan 20 on the core and vlan 30 on the other..both of them are layer 3 and running ospf...interface connection both vlans are not trunked.thanks.

On a switch running PVST and a bridging loop occurs within one vlan will the use of configuring max-free buffers per interface limit the deplition of resources and allow other vlan traffic to continue as normal?

If I am load balancing between two sites using OSPF and I add 3DES with GRE. Will I have any problems with my load balancing?

I have a 2610 with a NM-16-AM module and I have a external DHCP server, what I have to do in order the remote user gets it´s own address and configuration from the external DHCP (server)?If you can help with a configuration sample!

What does a switch do with BPDUs when spanning tree is disabled?In an example with three bridges in a triange, if one has spanning tree disabled the other two do not see each other and therefore there is a loop.does the switch act similar to a hub an...