Other Network Architecture Subjects

Hi AllI have this below mentioned command configured on my 3640 router. Could you please let me know the explanation of this command? I am unable to find the explanation on cisco.com.logging queue-limit 100.Additional information: My network has the ...

ILMI State is "UpAndNormal" between the routers(7200) which says that 0/16 PVC is up and both routers are reporting the correct Remote peer IP address.I have this PVC 0/364 which has "ILMI MANAGE" enabled (OAM manage is disabled) on both routers, but...

Hi,can any one help me controlling my ISDN router to Dial only for the interesting traffic.I have the following access list below which doesnt work.access-list 101 permit tcp any any eq domain access-list 101 permit tcp any any eq 8080 access-list 10...

I am building a lab with a 2509 for reverse telnet to the other routers. Everything is working fine except for one router. I am not able to reverse telnet to that one router. When I connect directly to that router via console, I have no problems, but...

Hello!I have a question regarding the token bucket algorithm used for frame-relay traffic shaping.What happens if a packet is larger than the token bucket?For example a 1500 bytes (=12000 bits) packet with a Tc of 10ms, Bc of 5120 bits and Be of 0 bi...

Hello all,I'm new to most of this and I would really appreciate any help. In my test lab I have 2 identical routers:7200VRX with a PA-MCX-2TE1 card.In the simplest form, can I just connect a crossover cable between these two cards, configure one rout...

Somebody can tell me? ThanksSincerely

Hi,We have a core switch (Catalyst 6509) with 8 Port Fiber Module, 96 Port RJ-45 Module & 16 Port RJ-45 GB Module. All the server's are connected to RJ45 Port (100 Mbps-Auto-Full Duplex). All these servers are connected to these ports.We have Veritab...

Can we configure a DDNS client in a Cisco 827-4V (12.2(15) IOS).The idea is to have an account in i.e. www.dyndns.org and by doing this getting the updated public IP address of the router.

AS1----------AS2------------AS3 Topology:AS1 is our local ASAS2 is our connected ASAS3 is another AS connected to AS2 Objective:At AS1 Accept all the routes present in AS2 exceptdefault route (default is generated by AS2)and any routes passed through...

HI ,I currently hve a setup of 2600 router with 8AM ( analog modem )network module card at HO. This acts as a RAS box for my Remote analog users to dial in and access the network. However the max connection speed for PSTN according to documentation i...

On a Frame-relay DS3 running 45M to over 250 PVCs with varialbe port and CIRs. Are there any issues with an MTU setting set at the DS3 side to a much larger setting than the remote sights??? note: all eithernet ports are set on both sides to defaul...

Hi,Just curious about this simple problem.I hv a P-t-P with encap as hdlc, A and B. Let say that i take a loopback from B the remote end. So In this case i see that serial and line is up and (looped) @ A end. Now i will ping my own interface i.e A's ...

I have Cisco 2924XL switches (IOS) running v 12.0 and ver 11.2.CW2K cannot detect these switches even after applying the latest patches to CW server. Do I need specific IOS version in the switch ?