Hi,
I have cisco switch IE 2000 , I am able to do SNMP GET/SET for basic MIB object.
But what can I do if I have been asked to add new leaf node to existing MIB tree for device(cisco switch)?
Please guide me to add leaf node into existing MIB tr...
One of our 7206 have problems with self-boot. Some says that the message system returned to ROM by power-on means that someone have physically booted the router or the we've had loss of power. Is this true or can there be other explanations for the o...
Hi,Been pulling my hair out on this one!! OK in my lab environment I have a hub (R1) & spoke (R2 and R3) network with a frame relay switch (R6). For some reason, I am seeing CISCO, status deleted on the spoke routers. This is not allowing me to PIN...
We have a Cisco NSS326 v01 Smart Storage NAS unit that recently had a failing drive. We replaced the drive recently, and the RAID 5 array has been stuck at "rebuilding: 0%" for days now. The replaced drive shows up just fine in the gui, with a "goo...
hallo we have some cisco2600 routers directly connected to a Catalyst WS-C2950-24 switch IOS C2950-I6Q4L2-M 12.1(9)EA1.The switch has default config.The routers and the switch have CDP running.On each router CDP see only the switch.If we disable CDP ...
Please suggest me can i upgrade all below switch with new IOS...
Switch TypeModel numberSW VersionSW ImageL2WS-C2960S-48TS-S12.2(55)SE5C2960S-UNIVERSALK9-ML2WS-C2960S-F48FPS-L15.0(2)SEC2960S-UNIVERSALK9-ML3WS-C3560X-24T-S12.2(55)SE5C3560E-UNIVERSALK...
Hi Guys,
I know may be my question is little bit weird, but I want to know how to calculate MB needed for one project to ask my ISP to provide me the speed on leased line, for example if my network consume 10 MB I have to ask ISP to give leased line...
Hello colleagues!I am starting an ISP. And need several principle advices how to arrange my network.The problem of RADIUS accounting is it's non real-time working mode. And if I need to arrange real-time accounting, am I to use NetFlow? That means, t...
Hi,
Our client has 2 nexus switches at their office now.
They would like to replace them into 4 Cisco 3850 switches and want us to configure them stacked 4 of them all together.
The models are as below;
WS-C3850-24T-S Qty:2
WS-C3850-12XS-S Qty:2
Is t...
Good Day,
Any can pls advice on configs for authentication from AAA with SSH on 3850. I have done the below:
conf taaa authentication login default group management localaaa authorization exec default group management if-authenticated aaa accounting...
Hi all ,
Now i have been troubleshooting an issue where in my security team wherein they are unable to form a cluster with two checkpoint devices . ( internal interfaces E1 on both).
They have told me that the cluster protocol (CCP) uses multicast ...
My question is if an ASA 5508 or 5512 could keep all the connection logs for 1 month. I will install the ASA 5508/12 just with firewall and any connect features in a 10Mbps Internet link. There will support maximum 60 concurrent users. Thank you i...
We have a stack of 5 WS-C3750E-48PD-SF. Each switch has a single C3K-PWR-1150WAC power supply, plugged in to a very large UPS. There are 10-20 PoE devices on each switch
I'd like to leverage a pair of RPS 2300s in order to act as an emergency back...
