Hello:MY problem is two cat6509 run hsrp authentication no work.ADD other cat6500 setting standby xxx priority 150 "sh stan" is R3 standby?R1 interface Vlanxx ip address xxx.xxx.xxx.1 255.255.255.0 no ip redirects no ip unreachables standby xxx p...
I had a cisco 837 with IOS 12.3(2)XC. The log always has the error message "Dec 9 14:58:45: %CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on Ethernet0 (not full duplex), with switch1 FastEthernet0/1 (full duplex)."But there is no error message ...
After configuring VLANs on a Cat4006 layer 3 module, i noticed the default gateways on each of the subnets were flapping when running a continous ping to them from each subnet.3548 were used at the access layer switches trunked to the cat4006 via gig...
IF LMI type is not configured…. Can annexD for instance, auto sense Cisco… or annexA ?? (I understand the router will listen on both DLCIs, 0 & 1023… and send 3-requests at specified intervals… router will use last LMI type reply….true statement???!?...
In the AP352 there are optional settings in the Express Setup Page there are two options in the "Optimize Radio Network for" settings. The first is "Throughput" and the second for "Range".My questions are: (And please FORGET about RF power vs range...
hi i have a cisco 2611 router, and last night my network monitor program send me emails saying that the ping service to servers in a remote location where unreachable. So what i want to check, is when was the last time my interface went down. i know ...
hi i have a cisco 3640 router, and last night my network monitor program send me emails saying that the ping service to servers in a remote location where unreachable. So what i want to check, is when was the last time my interface went down. i know ...
HiWe have a 7513 12.0(7)T 32 MB RAM and I'm trying to install a new VIP2-50 (with an E3 PA).I've successfully installed VIP's in this router over the years with no previous problems. Performing an OIR (slot 9) causes slots 0-4 to 'go offline', the in...
I have a 1751 with two additional ethernet interfaces as well as the built-in 10/100. I want to NAT on these interfaces to different locations (and different NAT). For example, my 10/100 is 192.168.5.x, ethernet 0/1 is 10.33.254.x and ethernet 1/0 ...
Dear Sirs, I just tried to upgrade my 3662 router memory To 256 MB.but the price are really different in market and all I need is CISCO branded or fully qualified memory modules. But I can't find any idea hoe to get it What is the original CI...
we are having a few hosts become unreachable, both with a server address and we had an interface on an mls become unreachable. If I go into the core mls's I cannot ping it, then I do a traceroute succesfully, then I can ping it. And everything is fi...
I have 2 Autonomous systems in this network that each have a router that provides a connection to the Internet. The Autonomous systems are seperated by a frame switch. I want to get hosts and routers that are located on an AS going out to the Inte...
I have a 5002 with 2 175 watt power supplies and a Supervisor II G. Status lights are all green. There is no 4 port module installed in the Supervisor II G.Hyperterminal shows nothing when plugged in. There is absolutely nothing. I have tried jum...
