I found this document saying you can configure two default routes using the "ip route 0.0.0.0 0.0.0.0" command and the router will load balance between the two routes. Is this correct? Is this something new, and if so what version of the IOS was it...
Is there any way of chaning the flash to Read/Write.I add addtional flash and when the router reboots, Is makes a second partition. One of which is Read Only) and I can not delete, erase or anything with it. I am using the Intel chip.
Hello All:Is there anyway with the CISCO IOS to load balance T1's beside multilink.We have 2 T1's and would like to say set s threshold whereby if traffic on 1 T hit 70%, all traffic in excess will route out 2nd T1. Thanks
I need to make a change to the startup-config on a 7206VXR router but can't find it. The running-config is different so I can't do a 'wr t' to make the change I need. In the startup-config there is a 'boot network ftp:....' statement which pulls do...
Hi all,I've found some similar subjects on the forum but not the exact answer to my problem, which is:I need to deploy a new E3 circuit to connect two offices and was searching for the right NM to fit in my 3640 (plus get a new router for other end o...
Hi,I have a Cisco3745 running IOS 12.2(15)T9There are E1 interfaces and MICA modems inserted.It doesn't work if I try to dial in. I always get this debug output:*Mar 1 02:03:58: IP: s=10.38.255.11 (Async87), d=192.1.1.2 (FastEthernet0/0), g=192.1.1....
Any ideas on what is the best way to design a network infracture to support IP cameras over the intranetFollowing are existing equipment Cisco MC3810,Firewall and 3com Remote Access Server AccessBuilder 4000RegardsRajendra
Hi All,In PIX, when use ipsec to connect to vpn client, there is a "split-tunnel"command so that the client just use the ipsec tunnel for the internal traffic. But for router, I search cisco web site (because I have on routers in my side now) I can n...
Hi, We have 2 locations one at India and the other at UK, the india router is connected to the UK router via a 2 Mbps and a 512 Kbps IPLC link, we want to use the 512 link only for FTP traffic, if we create a ACL on the 2 Mbps link and deny FTP traff...
I am attempting to get a Cisco 827H router working for a customer that has an ADSL connection that is already working (so I know that the line is good). It was sourced from another company and only the console cable and AC adapter were supplied (no W...
Was reading this example and got a qns here... Routers configuration : interface Serial 2 ip address 172.16.1.2 255.255.255.0 ip policy route-map test route-map test permit 10 match ip address 1 set ip next-hop 172.17.1.2 exit access-list 1 permit 19...
Can anyone recommend counters, logs or specific Sniffer captures that can be viewed or captured to tell if excessive broadcasts or multicasts may be causing trouble in my environment. I currently have approximately 500 devices running on a single net...
