Hi Is it necessary to have same Admin Group on both switches which are connected by a Port channel? i.e do they have to match exactly? I couldn't find any documentation which confirms this.Thnaks
What type of STP is typically used in a Data Center? PVST+, 802.1w, MST? Is there a white-paper that explains the similarities and differences of these various STPs
Hi,When I connect to the management centre for pix firewalls, I get the following message:1. The scope is set back to Global for one of the following reasons: 1. The device or group is deleted by other users. 2. The hierarchy table may changed since ...
all:i have just configured two of my new switches... one being a 4507 and the other a 4506. i have configured them to be layer 2 only (no ip routing) and have set up the 2 vlans that i need routed. anyway, i just want to test connectivity between the...
In this moment i have a cisco uBR7246VXR (NPE400) with version 12.2(11)BC2. When the Ubr is booting up shows the following messages:System Bootstrap, Version 12.2(4r)B2, RELEASE SOFTWARE (fc2)TAC Support: http://www.cisco.com/tacCopyright (c) 2002 by...
I have a card wic-1t in router 2610(12.2), but same the single one supports to me until 1728Kbytes.. But the client tien contracted a E1.. is necessary to form something in special in router so that the card can arrive until 1920Kbytes
I understand how the Cisco IOS “DHCP relay” function works when one DHCP server is defined. (i.e. ip helper-address 10.1.1.1), but how does it work when multiple DHCP servers are defined across a WAN link? Does it wait for response from the first DHC...
My router IOS is 12.0(21)S7How do I change the SNMP version to version 2 Presently it showsRTR#show snmpgroupname: test security model:v2creadview :v1default writeview: <no writeview specified>notifyview:...
Hello,I would like some advice please on what the above should be set for.I plan to roll pim-sparse-dense mode out over a large corporate network in London using Auto-RP very soon, and I plan to set the PIM DR manually to the HSRP active interface so...
Hi,I have 2 routers 7513 connected via a satellite link (HSSI interface with QoS configure on it) and some times (it is appenning very ramdomly) the link is falling down during 2 mn.Here are the conf and logs : router #1interface Hssi8/0/0 descriptio...
