Other Network Architecture Subjects

Hello,I have a number of servers connected to 6509 switch running CATOS 6.2(3).These are reporting Align-Errs and Runts. Align-Errs with CRC suggest problem with NIC , bad cable or bad port.How do I know if there are any CRC errors associated with ...

Is there somewhere I can change the telnet path within Cisco Works. I would like to open a different telnet application than HyperTerm.Actually, before installing LMS 2.2 1.3 update, it did open my other telnet application, now it wants to open Hyper...

I'm having problems finding the MIB for my 2621 running IOS 12.2. Can anyone point me in the right direction?ThanksMike

hi im having trouble finding PDF's detailing what each feature pack holds as in IP only , IP+ , IP/FW etcany ideas

What's address to management outband of WS-C1900C that is setting to default.I can't access to "Catalyst 1900 - Main Menu" by telnet application, only i can access to "Diagnostic Console" pressing the "Mode button" on the front panel (hold it)Switch:...

I don't know if this is the right place to post this, but I have the following problem:On an AS5350 with ios 12.3.3a with 2 E1s when I try to make an E1 link on the second port I get the error %DSX1-1-FIRMWARE_STOPPED: T1/E1 Firmware in slot 3 is no...

On the 48-port 10/100/1000 card for the 6500, the ports are grouped in "12's" - presumably clustered by ASIC. Is there any benefit in distributing host connections between ASIC's? If an ASIC fails, does it bring the whole card down?

HiWe got few 3500XL switches and we want to change the IP address of all the switches.Currently interface VLAN1 is configured with IP address in 192.168.1.0 network in all the switches.I want to changed this address to 192.168.8.0 (different VLAN...i...

HelloI have a problem trunking vlan between a 3Com superstack and Cisco 2950.The LAN has until now not been using VLAN:s, but I now want to create a second VLAN 2 named Video to transport that traffic thru the switches. There is no Layer 3 connection...

hi,I need to add 1 more dialer which will dial to the internet PAP Auth. how to go about. how the router will know whether the request is for Internet or Remote connectivity so that it will dial the required dialer for the config belowisdn switch-typ...

Hello,I want to connect an IDS to a switch, probably to one Catalyst 6500. The problem is I don't know how to configure a monitor port, I mean, a port which receives all the traffic. A not switched port.Some switches and routers have one specific por...

Dear AllI have CISCO router (2500) behind my cable modem.When i ping from my router to ISP gateway or anywhere else i get 40% packet loss.The router Ethernet is on default values. I have checked this problem with other cisco devices (2600 router, Cis...

Dear friend,We have our private environment with cisco switches.A cisco 6006 layer 3 switch is used as vtp server and the vlan configuration are send to 12 cisco 3548 leaf switches which are configured as clients. There is a situation where a switch ...

Does Cisco make a USB to RJ45 console cable? We have laptops that do not have a serial port. Thanks,RJ