Other Network Architecture Subjects

Dear All,I'm just having a question regarding Regional sites to Main Office Connectivity in a way that is cost effective..Let's say that i have 10 remote sites that must be connected to the main office? what i want know is:1- Is there any hardware [R...

I'm running into TCAM table problems on our Hybrid 6509 [6.4(3)/12.1(19)E1]. The error message is "%ACL-3-TCAMFULL:Acl engine TCAM table is full". I have researched it some, and I know what the problem is (we need to trim our ACLs), but I've seen m...

Hi,Is there a difference between using Protected Ports OR PVLANS, when they are relevant only to the Local Switch ?Will protected ports (on the same switch) be able to communicate , if the traffic is routed through a layer 3 device ?Does anyone know,...

hi all !I would be very thankful for help.As i have read from cisco.com server design must include access , agregation points and core points I can t understand configuration of core switches which have full mesh topology with aggregation switchesI...

What's a good migration strategy for moving into production a new CWorks server. Have new hardwareand latest software (Solaris 8, RWAN, LMS, DFM, nGenius) up and running in development environment.

I have a Cisco VPN 3002 hooked to a DSL Modem. I would like to insert a Wireless Broadband router in between the DSL and the VPN 3002 to share the DSL only and not the VPN. How can this be done??? Will be using a SMC Barricade as the router. Has o...

Error log entries. I am really looking for an avenue to research these log messages without going through this forum. Is there a place these messages are posted with possible cause/effect/solution?Thu Oct 09 11:16:08 MDT 2003: Running servlet{ jav...

Is it possible to mirror two ethernet ports on the same blade on a 7206? I would also like to know how it goes with a Cat6513 running IOS. Had problems looking this up on the web. Snoop?? Span?? Port Monitor?? monitor port? These terms don't show up...

Is it possible to mirror two ethernet ports on the same blade on a 7206? I would also like to know how it goes with a Cat6513 running IOS. Had problems looking this up on the web. Snoop?? Span?? Port Monitor?? These terms don't show up in the IOS...

Is there anyway that you can define certain ports to act as an uplink? I would like to eliminate the multiple cross over cables that I use. If so, how would you go about doing this?Thanks,

HiIs it possible for me to upgrade from CatOS to IOS on my C4306? Is it just a command to change from CatOS to IOS or do I have to change firmware (how do I do this on CatOS?)?xxx (enable) sh verWS-C4003 Software, Version NmpSW: 6.3(2)Copyright (c) 1...

Hi, Trying to integrate ciscoworks 2000 with hpov (solaris) when uncompressed the adaper integrater the following error occured. Any inputs....regards,shashank disk1/packages/CSCOjre/reloc/CSCOpx/lib/jre/lib/i18n.jar, 2748690 bytes, 5369 tape blocksu...

I have three CISCO3550-24,I want to install but I find they don't work. In the process of loading,I find these:Initializing flashfs...flashfs[1]: 16 files, 3 directoriesflashfs[1]: 0 orphaned files, 0 orphaned directoriesflashfs[1]: Total bytes: 1599...

I have a Win2k server that appears while doing network backups, is only able to pull about 4 Meg. It has a Gig connection to a 6509 that isn't reporting any interface errors. Any ideas.