HI,I just got a brand new 7300 router and powered it and it asked to upgrade the FPGA and i clicked yes.subsequently it started programming successfully but the end result is that the 7300-CC-PA card (atm enhanced E3 line card is not recognized and t...
Hello,I am using three 3500XL switches linked with GigaStack (half-duplex).The GBIC configuration is very simple : none !The VLAN configuration is the same : only VLAN 1.The "show controllers ethernet-controller" command shows some "Invalid frames, t...
Has anyone come across a problem with the DHCP client on the 2611 platform?A debug IP packet shows that the DHCP client is using 0.0.0.0 as its destination broadcast address instead of 255.255.255.255.Once the DHCP client is activated under the inter...
At a AS5300 when configuring the command 'no snmp trap link-status' underneith the serial 0/0:15 or dialer interface does not prevent traps from being send every time a RAS user dials in.To my believe this is caused by the fact that this command is n...
i read in some cisco docs that congestion rule of thumb at access layer is 20:1 and is work well .so can someone explain to me what it does it mean by "work well" !!
Does it possible to use IPSec over Frame Relay?I don't see problem but it's better to ask...routerIOS/VPN----Frame Relay---routerIOS/VPNBest RegardsA.Calligher
Hi There.We got an WIC-2AM card and we are testing that in a Cisco 2651XM.I'd like to use some AT commands for spefic configuration but the URL http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis3600/sw_conf/firmware/analogat.htm#13434...
I am trying to configure an 837. It works fine when I configure it using CRWS. However, when I use the SDM, I am unable to connect to the Internet. When I debug dialer events, I get the following errorUTC: Di0 DDR: Cannot place call, no dialer str...
Am I correct in thinking that I can configure multiple standby groups on a Cisco 3640 HSRP pair for ethernet & token ring i.e. two ethernets as one standby group & two token rings as one group. I could only find relevant information for 7200 routers?
Hello AllNeed some urgent input over an issue. I have a CAT5500 with RSM (I know, I know... they are old!!) This morning RSM rebooted itself 3 times and lost the config. I saw that some twart has change configuration-registry to 0x2142 a few months a...
