Other Network Architecture Subjects

I have just installed CiscoWorks RME and was wondeirng how do i display the devices by their hostname instead of IP.

Have a few remote sites that require backup to their existing DS3 facilities. In some cases multiple T1 links (3 from some sites & 5 from others) should be sufficient for backup purposes at this time. The number of T1s and sites may increase. I'm co...

Hi, Is NAT fully supported on 2600 EtherSwitch module? Is there any limitation?We realised NAT is not supported on Cat4, and now we need to find a workaround.thanks

I am trying to apply ipx network numbers to subintefaces and keep getting the following message. "Encapsulation already in use by IPX network A, on interface Ethernet0.1"I am using ios 12.0(26)

i am trying to map my network from our 6500 core. Am i able to bring up browser and see the chassis, manange ports, vlans, etc?if not, what do i need to do this?i currently have 2 (two) WS-X6K-SUP1A-2GE in slots 1 and 2. Will this do anything for m...

Has anybody seen following message before . Port gig 1/1 is a trunk which a member of the channel to another switch. The channel shows the port as connected25/06/2003 11:56 AM WDRCSW2-Port 1/1 · short wave fiber gigabit ethernet Physical Address cha...

HI In a native IOS what is the use of Swtich prosessor when everything like VLAN VTP is configured on the MSFC( i.e route processor ) then whatz the use of the switch processor ??please enlighten me on theisNagu

hi alli m facing a strange problem at present.we hve a leased line of 2Mbps capacity with one of our site.The link is up and working ok.Theres no rate limit or nothing set on the serial interface on both the ends.the thing is the remote end users com...

I have a cisco 1601 and would like to disable Kazaa, msn messenger and yahoo messengerHow do i block them ?

Hi i have bundled 2 gig port to form a etherchannel and it workign finebut when i use this command sh etherchannel detail -------------------Port: Gi1/1------------Port state = Up Mstr In-BndlChannel group = 100 Mode = On/FE...

Hi,One of our customers is using an old Cisco LAN2LAN ISDN card (version 1.4.2) on a DOS PC to access our network. We have been using CHAP for authentication and that has been working well for a number of years. However, now we want to use PAP instea...

Hello,If any one know about a freeware or shareware that manage snmp traps of cisco equipements please let me know and thank you very much...Mourad

We have 2 site office both end equipped with isdn infrastructure. can cisco 801 router doing ip routing (router 1 dialing to router 2) using the isdn line.sample of config please

Hi I have 7200 router. this is output of sh verCisco Internetwork Operating System SoftwareIOS (tm) 7200 Software (C7200-IS-M), Version 12.2(6c)M1, RELEASE SOFTWARE (fc1)TAC Support: http://www.cisco.com/tacCopyright (c) 1986-2002 by cisco Systems, ...

I have IPM running on W2k configured to use the SA Agent between two cisco routers. One is configred as the target and the other as the source. Within IPM, thresholds have been set, if the thresholds are breached, SNMP traps are generated at the rout...