Other Network Architecture Subjects

Does Cisco offer anything affordable in the Gigabit switch area? I've seen the $10,000 dollar 3550 series. I can't justify a 12-port switch that costs that much just to bring Gigabit to the desktop or to a group of 10 servers. I understand this switc...

hi all,we have two departmernt LANs we want to connect, but both are using the same network ip (e.g. 172.16.0.0) and changing the addresses on one site is not possible.I heard that for this kind of scenario is a solution available with two NAT tables...

How do i use CiscoWorks to upgrade IOS on multiple switches and routers, at the samw time??

Is connecting a Fast Ethernet hub to a Catalyst 5500 a bad thing? If not, what is the proper way to connect them.

Hi,I have a 7500 router with 4 VIP, and this device was running ip CEF, but the router had a level CPU Utilization near to 50%. Then CEF Distributed (dCEF) could be a good way for low the CPU Utilization. For enable the dCEF I configured ip cef distr...

One of my clients have a 5 nod network where we up to recently used Cisco 1603 without any problems. Since this model is not possible to buy in Sweden anymore we started using the 801 model with the IP Plus package.The problem is that on one of the r...

We are looking at building a couple of Linux clusters to store and process some large volume data sets (2 x 6 TB in 0.2-0.5GB granules). I am interested in finding out more about how the Cisco switch backplane will handle these connected clusters if ...

I'm currently running 15 Catalyst 2950s (which are cascaded in groups of 3 from a 3550). At random intervals in the day, one or more of the 2950s (different one each time) is just *locking up* (lights go solid) - the problem can only be rectified b...

I'm currently running 15 Catalyst 2950s (which are cascaded in groups of 3 from a 12 (GB) port 3550). At random intervals in the day, one or more of the 2950s (different one each time) is just *locking up* (lights go solid) - the problem can only b...

Anyone had any issues when using Win2K Hyperterminal when consoled on to a Cat 6000?

If you want to summarize a route (10.66.32.0 255.255.224.0) using the interface ip summary-address command at one accessrouter can you summarize a portion of that same range from another access router (10.66.60.0 255.255.252.0)? Technically the latt...

I am having a problem with a CISCO 2600 and it`s ethernet. I had configured it`s ip address and routing protocol with sucess. When I use the command "no shut" the interface comes up ok.... and the routes are placed on the routing table normally. But ...

Hello,is IOS supporting ip nat inside with 2 Dialers?.I needed to conect to 2 ISP , the 2 Dialers are configured with ip address negotiated and ip nat outside.Thanks.

In my CWW 6.1 with CV 5.4 with the latest 4500 IOS Packeges installed the following error message appears: "can't find applicable device package for....." and "device package for this device is not installed or you are attempting to open a componenet...

can i configure a router to reload automaticaly after the specified time.Rehan