Other Network Architecture Subjects

hi, i have a 1720 series router i intent to connect it to another router but i only have a wic. is there any way to connect it to another router? if yes which series of router should i get? i look at the wic it is stated there serial 1 i remove the m...

hi, i have a 1720 series router i intent to connect it to another router but i only have a wic. is there any way to connect it to another router? if yes which series of router should i get? please advice. thanks a lot in advance.

What would cause the following error when installing a T1 DSU/CSU WIC in a 1601 Version 11.3(11a 00:00:08: %C1600-4-BADINTFC: Interface 2, (0-1 Onboard interfaces 2=WIC)Invalid interface (Unknown, Uninitialized or Bad Cookie value read)

hi i have a customer whos having leased line and isdn as his backup.he needs to check the status of the ISDN without any manual intercetptions regularly once in a week.while testing the same he doesnt want to make his LL down..i planned to use snapsh...

I have a C3660 which hangs typically after a 2-3 days of being in production. The only resolution to bring it back into service was to power it off & power back on again, which doesn't seem to be a feasible option always. The router has OSPF as the R...

We are in the process of purchasing a 3720 PRI bundle to be used as a digital dialup solution. Can 2 of the channels PRI channels be used for a BRI ISDN backup solution for a head router at this site? thanks

Hi ppl,I have two 6509 as L2 core switch. When I tried to add it in RME 3.4, all ports on it are working properly except the one connected to the CiscoWork server. When RME starts polling the device, the 6509 can't response to ping!!! After 6 mins, t...

Hi Guys,I need some help in configurations for router dialing out to Internet using Dialup modem. Is it possible for router (2610/1750 with Async/Sync port) to connect to Internet via dialup modem (DATA) dial out using a valid ISP Internet account / ...

Which Cisco management tool is the proper tool to manage and monitor a Cisco MPLS network?Any links to descriptions of capabilities would be appreciated.Best regards,Michael.

Can not get this module to work in the Cisco 2610XM router. Have tried 12.2.8 T and 12.2.15 T IOS. With the module install the router continue to re-boot. Is there a specific IOS need to get the router to recognize this module.

PC A in vlan 2,and PC B in vlan 3,so can PC A and PC B in same subnet?

On my Catalyst 3524 I can change my management vlan. With the Catalyst 3550 I have not been able to find a way to do this.Is there a way to change the managment vlan from vlan 1 to some othervlan?Thanks Ken

I have got SSH and use it to connect to our Linux machine. I want to use it to remotely connect to our routers instead of using Telnet, which I think is not so secure.How do I configure the router for SSH log in. I have notice that the transport inp...