Other Network Architecture Subjects

Hi folks,I have a small home network consisiting of a cable modem, PIX 501 firewall and a 2912XL Cat Switch (running 12.05 Enterprise Edition software).I can't get npt to work on my Cat swtich. The PIX firewall is working fine and locked to the publi...

if i have to put a satatic route entry for 192.168.1.2 255.255.255.252.What it will be likeip route dest mask hopregardsManish

I m looking for ONS software download from the software center. I m looking for 4.0 and 3.3 images. and I also see two images each 25 megs in size, one with a SDH in the image name, and one without an SDH. I want to know which one to download, and al...

Phones work...PC's don't....Any ideas? I add the PC to a static access port and I can ping everything. Same config on a 3550-24 works fine...weird....Oh, and the "switchport trunk encap dot1q" command is NOT available on this platform...even more wei...

There are a few clients that take an interminable time to connect to the LMS server and to subsequently load new menus etc. All clients are more than the required spec and the majority of the workstations in the network connect without any problem -...

I'm discovering the new switches 3750 (excellent by the way) and noticed that the 1000baseSX fiber connector is an LC type. Is it the same as MT-RJ connector ? if not, is there a converter to MT-RJ ?Thanks in advance.

I have a 2620 router with single ethernet interface. I want to connect two different LAN segments to this router. How to do this ? Can anyone help me?

Installed the CMS on a new pc. Now it is asking for a user name and password for access to basic level 15. I didn't configure a password or user name. Is there a generic password? I'd like to be able to use the browser interface to manage my swit...

After configuring the router, the config files are saved by using "copy running-config startup-config" command. when the router is rebooted, instead of giving the hostname> prompt, it goes to initial configuration mode and asks for enter initial conf...

We have a LAN with a catalyst 3550 EMI configured with four vlans. The LAN also has a catalyst 2948 and a 2950, both are layer 2 switches with a fiber gigabyte connection to the 3550. gateway | ...

how can i remove the flash partition at 3620

Is dcef supported at all on a 6509 hybrid system. I was interested in the WS-X6516-GE-TX module. To enable DCEF, WS-F6K-DFC needs to be added. However, it appears WS-F6K-DFC is not supported on a hybrid system. Is there any alternatives?

Hello,how I realize a redundancy with 2 Switchen?I have 2 catalyst 3550 (EMI) and would like to append other Switche to it.It isn't always Cisco switche but also 3 Com and others.I would like to produce with each of the other Switche with a one cable...

I have a new catalyst 4006 with super engine III WS-X4014. and WS-X4148-RJ45V inline power card.The Rom version on super engineIII is 12.1(12r)EWI want to boot from bootflash with CatOS version 7.6.1, doesn't work. I also download the Rom upgrade v...

Dear All,We are connected to 30 places thru leased line .Now i wanted to configure ISDN as AutoBackup.Now problem is here.If I am configuring place A bri port as a backup of leased line ( it will dial B )then it goes in standby mode.and B will dial ...