Greetings,I need to connect an asynchronous 56k modem to a synchronous serial interface on a 7200 router. I would like to know if this is even possible to do so, and if not is my only option is to use the aux port? Please let me you if you have any i...
Hello,we use an AS5300 for analogous dial in.If we do a local call, the PC can establish a connection.But if do a long distance call with the very same configuration,then no connection is established.We get "disconnect 0x6008", that means that it too...
Can anyone help me with the usage of the Cisco DIal Out tool in combination with a C3620-BRI8B-S/T. What I need is config for the C3620.ThnxIDJ van der Ven
hi, i'm looking for TFTP to download in the cisco web site for the whole night. but i dont seems to be able to find it. can any one please help? thanks a lot.
Hi,I'm desperetly looking for tools to monitore multicast routing entries and traffic.While using Tibco RdV (I know it's crap...) and PIM SM in trading floor environments we have many (S,G) entries and we would like to measure the amount of traffic b...
i have configued a PRI for backup to leased line with max links of 10.channels come up one by one after evry 30 secs .then after some time error comes :14w3d: Se1/0:3 PPP: Missed 5 keepalives, taking LCP down14w3d: Se1/0:3 PPP: Phase is DOWN.wht is t...
I am interconnecting two routers with an ethernet crossover cable.What are the conditions that toggle the status of the interface and the line protocol.?
I have 3 catalyst 3550 in access layer. each catalyst is connecting through a fiber to the core catalyst 4507 using trunking. The servers are in separate VLAN than the users. how do I assing Ip address to each user in different vlan.can I create...
I have a remote site dialling in to 1 of 2 3640 at my central site, both 3640 have a PRI but we have been having a few problems with them so I would like to be able to configure the remote site to dial either of the 3640's. My thinking is that if on...
The pa-8t card only allows a total of 128 channels configured and only 5 full T1 PRIs can be configured. I remember a Cisco doc describing this limitation but I can't find it. Anyone know where it is? Does Cisco intend to fix this to allow all 8 port...
I am implimenting new network as an expansion to an existing network.Customer has a WEB server meant for intranet users having IP address 90.0.5.10. At the final stage,I will move that web server in to new network segment having address of 172.20.50...
Hi I have a 2600 with 4 sites connected over FR. They were working fine until today I had all the 4 PVC's status was showing DELETED. There was nothing wrong from the telco side. When I restarted the router the PVC's came ACTIVE again. Anyone has an ...
Hi alli have two gateway routers connected to two different ISPs, each router connected to one ISP.each router is running EBGP with the ISP connected to it, and we only recieve default routes from the ISPs, IBGP is running in my network.how can i loa...
