Other Network Architecture Subjects

I need to configure 801 router on leased Line ISDN. Can any one give me the link on cisco website where the commands and configurations examples are postedbest regards

I have a router running on 2 ISDN line with 2 ISDN cards?Can thes both line do a load balance?same goes to adsl?

Is there any way to limit the number of NAT translations that are cached on a 2600 router? Or at least some way to set the size of the cache or expiration time?Thanks in advance.

does anybody know if this feature (rfc2136) is supported by the 827 platform?if not, do you know if there are anyplans to support it in the future?regards,c.

Hello all, I have an issue where my end users are complaining about latency issue between two offices. One office, the main one, has a 3640 router and the branch office has a 1720 router. The connection is a T1 that has a meet point between two...

Hi,For monitoring the site to site response , I need to configure rtr on Cisco 3662. But when i give the rtr command, I receive the error "%No memory left to create probes". Memory of the router is 64MB and the IOS is 12.2 which supports rtr.Below a...

Hi,I try to read the MAC table of the following switches - 3548-XL-EN- 3550-48-SMI- 6500 But the only address i get are the swithes his one address..Is there some one out there that has solved this problemI have also a problem with reading the Duplex...

Our Internet perimeter router has two Ethernet connections to two different ISP routers. The routing process is assures with static routes.How can I configure perimeter router to perform load balancing between the two ISP's connections ? Can anyone s...

I have a BVI set up on a 2948 L3 and it works fine for isolating traffic, it is configured as a second subnet and I have a wireless accss point set up on it. I can communicate with the access point but users can not validate. My question is if this...

Hello,I am trying to configure netflow on C3550-12T. "show ip cache flow" command displays only flows that goes to "Local" or "Null" destination interface. Flow exports works in the same way.It looks like: [*] no interfaces uses flow acceleration, b...

From the Class Manager I'm unable to rename/delete or cut a previous defined Class. It displays: A Service By This Name Does not exist.However the class is created and displayed in the list. The reason is probably that the service name has a slash (/...

Greetings all, We are tryin to get a back-up configuration for our ATM switches (BPX 8600). We have Cisco Wan Manager (ver 10.4.10 Patch 4) on Solaris. Through the tool "Config Save and Restore" we are unable to do this. Reading the "Wan Manager User...

I need to configure 801 router on leased Line ISDN. Can any one give me the link on cisco website where the commands and configurations examples are postedbest regards