Other Network Architecture Subjects

Enabled an access list on a 6509 MSFC as follows:access-list 110 permit ip any any logaccess-list 111 permit ip any any log-input..applied them to an interface:Vlan11 is up, line protocol is up Internet address is 10.1.1.1/24 Outgoing access list ...

Hi there,We're running DFM 1.2.4 with CW2000 (Windows) and we're having a problem with serial interfaces. We have a number of routers interconnected via T-1's running PPP. However, DFM on discovery sets these interfaces to "ONDEMAND" mode, which in...

Hi.....One of our analysts submitted a malformed device name that included special characters {$* into RME. We can not delete the devices from the suspended devices list. We tried going through the GUI, as well as using deleteDevice.pl, has anyone el...

Thank you for checking out my question.Please check the topo below. ******************A1 /[==]******************** *************Area 0 / [==]A2 *****************************B1 [==]/ ***| ******* *****************Area b**B2 [==]****| ******Area a*****...

Folks,I have a 2950 24 port switch with 2 gigabit ports. One is used for an uplink with another 2950. The other is an UTP card to connect to a server. When i plug the server in i can see activity on the server card & the switch but can't log on or pi...

using dialup after connecting using tacacs+ can we chande the domain password.

Hi. We have some switches linked together to form a DMZ with a variety of hosts and two PIX firewalls connected. If we try to ping a host from the switch it is attached to, the ping fails. When the arp cache is viewed, the entry for the server IP ...

When gather incoming netflow traffic with NAT, the local outside address (before NAT) as the destination is represented there normaly. But this info is quite unuseful for the accounting. Does somebody know, how to determin the local inside address (a...

Hi allI am having problems with 2 801 routers that I have configured for ddr from router1 to router2.Router1 will dial to Router2 but no traffic will flow. I have included configs for both, please help if you can!!ThanxAde**Router1**Current configura...

Ok here is the situation. We have two different isps and a 3725 router. I would like to do load sharing/load balancing. From what I have been reading I can do that with CEF and BGP or am I not reading this correctly? From what I understand BGP is...

Should I expect to see every Config Management trap received by Dfm in the FileNotifier log file? I.e. if I send DFM 10 Config Change traps should I see 10 entries in /opt/CSCOpx/objects/smarts/logs/DFM-alarms.log?I have a Solaris 8 machine with jus...

Hi Everyone. We have 2 Cisco 1700 Routers Connecting two of our remote offices. Each have one Netware server. Bith Routers configured to route both IP and IPX.. The IPX network seems un reliable for we loose connection constantly while IP Clients st...