Other Network Architecture Subjects

Hi all!I have a hub and spoke topology with the peripheral connected through2 link to hub. The one with Frame Relay and the other with backup ISDNwith another router (Cisco 805 and 801). I've setup the rip v.2, the peripheraloffice go to the Internet...

Hi There,I am trying to configure translational bridging but I have a few questions.1) When it says it will only work with non-routable protocols, how does the Ethernet segment talk with the Token Ring segment?2) I have configured it on a 2612, and ...

Here's the problem;I'm trying to know if it is possible for me in a router make SMTP traffic leave by an interface and HTTP for another interface. Example:SMTP - Serial0HTTP - BRI0How can i do this?Thanks in advancedSSousa

How do you change the Arp cache timeout on a 2900XL Switch.

I'm trying out the LRE solution at one of our older facilities. I'm having trouble patching the RJ21 pair into a 66block. I'm connecting circuit-1 (pins 1 & 26 on the RJ21) to the 66block pair which gets forwarded to the workstation jack where we a...

I'm looking to provide network connectivity for a couple of clients - a hotel, an appartment high rise, and a music studio. All clients have common criteria:a. Require fault tolerance/failover on multiple WAN connectionsb. Require load balancing on ...

I am trying to find following information for 3725 routerVolt Range Cycle Average PowerCan any body help ? ThanksAltaf

Hello Every body , We are going to use BGP4 on a 7120 router , and I would like to know if 256 mb system memory is enough.. to use BGP .. 256 mb is the maximum we can fill in our router .. Thank you very much for your help Marc

I don't know how to monitor 3550 utilization.I can show system to view peak traffic on 6509. Are there any like command on 3550? BTW,I know sh proc cpu and sh proc mem. thanks!6509> sh systemPS1-Status PS2-Status---------- ----------ok okFan-...

Hi, I have a problem with several PC's that have a Intel Pro 10/100 NIC.These PC's are attached to a Catalyst 3524 with the IOS c3500XL-c3h2s-mz.120-5.4.WC.1.binThe connectivity is poor because the ping is lost.Can anybody help me?Thanks in advance

Going to start digging in to this, but wanted to ask in case anyone already has. Anyone know if there are any SNMP OIDs associated with MLS and the MLS cache. we need to have an automated task run that would nice to call an SNMP set to clear an MLS...

HiHow hot are the Cat3750 switches !!!!!! very exciting...a couple of questions:1. Is there a Cat3750 with all fibre support available ?2. There are no performance figures for L2/L3 on the Cat3750 other than the 32G stacking bus. Does anyone know wha...

where i can find integration of ciscowork2000 and ibm netview in www.cisco.com , thx

I have recently installed a Cisco 1721 router for 512 kbps internet leased line. I want to install another internet leased line on the same router, but dont want the traffic from s0 to s1 or vice versa. I mean i want the traffic to remain seperate fr...

Hello colleagues,I have Cisco Internetwork Performance Monitor installed in a Microsoft W2K cluster. The failover fails because some of the services used by IPM do not stop properly.Here are the services and the respective W2K processes: IPM DB Serv...