Hi I have a problem, I have a switch 6509 with two supervisors, one of them was with alarm, so I entered to the device by console, and it was in mode rommon, so what I did was to make that load the image, after I rebooted the device, all the led turn...
I was trying to pull a NX-7K to see view the line cards but I received the following error msg: MessageCannot find applicable device package for 128.137.255.1.This error could be due to one of the following:- The device package for this device type i...
I uploaded the most current firmware on the phone. It will show a TFTP file error on phone display when booting up. I'm assuming the firmware did not upload correctly. I tried reloading the firmware and it shows the same issue. How do I completely er...
With reference to cisco's document on BGP Best Path Selection Algorithm (http://www.cisco.com/c/en/us/support/docs/ip/border-gateway-protocol-bgp/13753-25.html). Out of given 9 paths why 6th has been selected even though AS_PATH for 8th route is bett...
I have this issue on one of my asr9k routers. pmo4 & pmo12. re-seating these made no difference. so swapped pmo4 with pmo0 and pmo12 with pmo8. I am now seeing alarms for pmo0 and pmo8 should I be looking to replace these pmo's ?
Hi,Which is the best traffic load balancer, with 3-4 WAN ports and 1 LAN? what is your experience with it? Does Cisco have any equipment that performs load balancing? What are other vendors options?Best regards,Brj
Hi,Can i use my WAN interface ip as the GRE tunnel source ip in my cisco router.Is there any issue if i'am assigning a private ip to the GRE tunnel interface.
i have a new Cisco 2960x and an existing HP 2910al. I am OK with the set up i interface hp and Cisco all the time with copper but this is the first i have had to with fiber. i know Cisco switch will want a Cisco gbic (can get around that with service...
Hello,I have stacked 6, 2960x switches with the supplied 0.5m FlexStack cables, however my "sh switch detail" doesn't match up to how it's cabled. I found documentation on how to cable 4 of them with 0.5m cables, but not 6. Could anyone explain or po...
Dear All, I had tried IPsec with fast Ethernet 0/1 it works fine but when i tried to map same ipsec crypto to tunnel1 {VTI} interface IPsec not working. My remote Site checks for source IP of fast Ethernet 0/0 {Proxy ID in Juniper} I tried to MAP c...
I am attempting to create an alarm for Port not Forwarding and using the Major alarm relay for a port. When I apply the changes I make on Cisco Network Assistant as well as through CLI, the changes I made are not saved. I am doing this all under a ne...
