hello, Can any of guys say how to trace the "debug sigsm digits" command once I entered into my modem slot with "dsip console slot 11". Any URLs to understand the "debug sigsm digits". We have more unanswered calls as the m...
We have a significant and recurring issue in which PCs will become rogue master browsers. We don't have the human bandwidth to touch every desktop and perform the recommended registry hack to prevent PCs from iniating and winning browsing elections....
Currently, we have a Cisco PIX firewall model 525, IOS 6.0(2) Pentum III 600MHz with 128MB Ram with 2GE and 2FE ports. The Cisco PIX firewall device manager is version 1.1(2).The Cisco PIX firewall gigabit interface 0/1 connects to a Cisco 6500 switc...
I have 2 2610 connected to a serial point to point link but I can't get them to ping the serial or ethernet. Here iCurrent configuration:!version 12.1service timestamps debug uptimeservice timestamps log uptimeno service password-encryption!hostname ...
I have c2950T switch and c7204 router connected to each other with port-channel including 2 fastethernet interfaces. sh ether load command in switch shows that switch is load balancing basing on source mac address but i can't find any commands to see...
I would like to use a policy map and acl to stop all Code Red from entering my network on my 3640 router. I have 4 serial ports and 2 fast ethernet ports. The serial ports are connected to 2 different ISP's (2 T-1's per ISP). From some of the thing...
I have a serial interface that goes up and then back down about every 30 seconds. Does anyone know of any debug commands that I can put on this sub interface to determine what could be causing this. I have 14 other remote locations workling fine. I a...
HelloWe have a customer that has a demand to know how many XbaseTX ports that exists in the network on a monthly basis. The network has around 2500 Cisco routers/switches, fixed configuration as well as modular devices.Counting xbaseTXports is not ea...
I am really confused about multicast group concept. Is it something we need to configure on the router/switch or it is an arbitary group automatically created by the router?Let's say I have two stream servers, do I need to assign them a Class D IP? ...
I would like to disable the telnet access to my router and switches and replace it with SSH. What is the requirement, and what are the command to set it up?
Hi, Few clarifications on IBGP. Documents says IBGP is more flexible and has loop free architecture compare to other IGP protocols, does it mean OSPF is inferior to IBGP in providing loop free environment. What prevents IBGP being d...
Hi All,When use BRI interface running ISIS as a backup link, How can I config it? Because I can not use the command "ip ospf demand-circuit " like OSPF. I can use " backup interface bri x " command in the primary port, however, is there another metho...
I would like to use a policy map and acl to stop all Code Red from entering my network on my 3640 router. I have 4 serial ports and 2 fast ethernet ports. The serial ports are connected to 2 different ISP's (2 T-1's per ISP). From some of the things ...
After a password recovery as it is described on Cisco website, on Cisco 1700, I always have " sistem configuration dialog" after I relood or start the router.with gratitude,Dragos Iordand.iordan@bu.brauunion.ro
