Is it possible to have two default routes such as 0.0.0.0 0.0.0.0 172.19.0.3 and 0.0.0.0 0.0.0.0 172.20.0.2 ? This is for rudundancy and I would want traffic to travel over the second one only if the first one became available? I don't think this c...
What exactly are the channel groups used for and is there a way to remove them? I'm seeing these groups in my 4006 and am trying to create gigabit etherchannels to connect to 3550 switches.Admin Group Ports----------- ------------------------------...
We're experiencing difficulities maintaining an IPSec tunnel from our branch site PIX 506e to our central office Nortel Contivity 4500 Extranet Swtich. Does anyone have ANY VPN interoperability reference info. that supports the Cisco to Nortel site-...
Hi All,I want configure the CAR on a Cisco 7500, to limit web traffic.I want to understand how can I effectively calculate two parameters of the "rate-limit" command: burts-normal & burst-maxThanks in advance,ByeG.
Hi,what are the basic requirements for network devices so thatthey can be used together with CISCO Works?From a single release note I got the information that one shouldupgrade IOS devices from11.3 or earlier to 12.0 or later. But that's all I found....
We have a new server and new version of CiscoWorks LAN Mgr. The server is dual Xeon 1.3G processors with 1 GB RAM. Can I also safely load CiscoWorks Routed WAN Mgr and CiscoWorks QPM on the same box? Thanks.
--begin ciscomoderator note-- The following post has been edited to remove potentially confidential information. Please refrain from posting confidential information on the site to reduce security risks to your network. -- end ciscomoderator note -- ...
Hi,does anyone know what this error mean ?? Respectively is there any action necessary, because there war´s no error in the network !?Apr 1 01:12:37 router1 77: Apr 1 01:12:35.708: %MISTRAL-SP-3-ERROR: Error condition detected: TM_NPP_PARITY_ERRORTha...
Hi,I have VMS 2.1 with Security Monitor installed.I want to create an event rule based on the filter : severity >= High, with : notify via Email. So I select in my rule the choice Notify via email, and in Administration > System Configuration > Email...
--begin ciscomoderator note-- The following post has been edited to remove potentially confidential information. Please refrain from posting confidential information on the site to reduce security risks to your network. -- end ciscomoderator note -- ...
Is there a difference in the way an acl is handled when doing a config net versus applying the ACL line by line . With a config net is the whole acl downloaded before it is actually applied or is it handled the same way as a cut and paste of ...
