IRB Routing and Prioritization options.Routing on Inside LAN Ethernet at each end, with Bridged WAN.How can you Prioritize traffic with Bridging happening on the WAN links?Thanks,Bob
IRB Routing and Prioritization options.Routing on Inside LAN Ethernet at each end, with Bridged WAN.How can you Prioritize traffic with Bridging happening on the WAN links?Thanks,Bob
I am facing a problem for my dialin clients. We are providing them dialin facility to our office network to access internet through our office lease line, so in this regards we installed Microsoft ISA Proxy Server and given them permissions to access...
According to spec A 4506/4507R with sup 4 has 64G backplane, forward 48Mbps. Sup 4 has 333 MHZ CPU.A standard 6509 with sup 2 and PFC card has 32 G backplane, 30 Mbps. Sup 2 has 300 MHZ CPU.is a 4506 faster than a standard 6509 (no SFM)?I know some...
Does anyone know of any Cisco has any Big Brother monitoring modules or scripts?
Hi,I thought that the base flash memory on the 827 could be incremented by either a 4MB mini-flash or and 8MB mini-flash (to provide either 12mb or 16 mb total available flash memory space.Has anyone actually done this? Are there any hardware or sof...
I am facing a problem for my dialin clients. We are providing them dialin facility to our office network to access internet through our office lease line, so in this regards we installed Microsoft ISA Proxy Server and given them permissions to access...
I just bought a used 2500 router over the internet. I tried connecting through the console port but I keep getting an error. This is the error:Bad memory - wrote zero, read 0x00010000 at location 0x00000010What can I do? The first time I started t...
Hi All,I'm setting up a Cat 4507 w/ dual Supervisor IVs running IOS 12.1(12c)EW.1. I noticed that the active Sup is in Mod 2, even if I force it to fail to the 1st Sup, it will change back to the 2nd one after a few minutes. I've swapped engines, bu...
Please can someone tell me if I am going crazy.The way I understand EIGRP to work out feasable sucessors is the following :-Feasible distance. This value is used in the feasibility condition check. If the neighbor's reported distance (the metric afte...
If decided to use HSA on 7513, for router redundancy is it still necessary to use HSRP on a 7513?
Hello,I have an optimum online cable account. I will be using a new uBR924 as my cable modem. The outside interface of the cable modem will have an isp assigned IP address. On the ethernet interface, I want to create a 10.x.x.x subnet.Then I also hav...
Hi, I would like to know if it is a good practice to have more than 25 routers in the backbone area. Thanks for the advice!Regards,asanes
Hi,I would like to know the actual impact of loopback command in interface mode.I have two router connected over WAN link of 64 kbps capacity.R1---modem---PSTNmodem--------PSTmodem----modem----R2At router end we have V.35 Interface and modem side G.7...
I am facing a problem for my dialin clients. We are providing them dialin facility to our office network to access internet through our office lease line, so in this regards we installed Microsoft ISA Proxy Server and given them permissions to access...
hello, Is there any ways to represent a RID by its hostname without using DNS resolution in a OSPF network. Any commands to configure ?ThanksDinesh.K
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
02-20-2024 07:45 AM | ||
02-15-2024 09:08 AM | ||
02-14-2024 04:00 AM | ||
11-10-2023 09:28 AM | ||
11-09-2023 09:30 AM |