Other Network Architecture Subjects

We have approximately 34 field sites, 9 cluster sites off of frame relay connections and 6 individual sites off isdn connections. They come in through 3640 routers-one for isdn and one for frame relay. Those routers come to a switch that either for...

I have a dial up link between two routers using the serial ports and synchronus modems. I set up a simple dial link like this on both ends except for the ip and phone #s. Encapsulation is hdlc and no authentication. interface Serial1 ip address 10...

Im currently employing a 1720 cisco router for our frame relay router and we currently have 25 (sub-interface) frame relay links connected.Recently we have noticed that some of our sites goes down and upon checking the links we found out that the PVC...

Hello,I curently have a cable modem connection with a cable modem provided by my isp. That connection leads into the WAN port on my Linksys Broadband router. I then share that out to my LAN.What I want to do is the following:Replace my isp modem and ...

Hi All,If in the following case:R1--R2--R3and R2 syn time with R1, R3 syn time with R2. If I don't use "ntp peer" command, so in R1 should use "ntp master" command to define the master and in R2 should use "ntp server" command to point to R1 as time ...

hi!i need to determine CHECK RADIUS attributes supported by IOS 12.2.thanks in advance.-ian

We wish to connect a number of serial interfaces to our network using NAT. To allow the various subnets (outside) to view the server host (inside) as belonging to their address space we want to NAT multiple static global addresses to a single static ...

Has anyone experienced the following problems with a Cat 6500 with dual Sup 1A .%SYS-1-MOD_INVALIDSEQ:Bus asic invalid sequence occured on module 8 2003 Mar 20 14:16:53 %SYS-1-MOD_INVALIDSEQ:Bus asic invalid sequence occured on module 92003 Mar 20 14...

There are three cisco switches in my network, which are connected as following:3550-12T <--------> 3550-24-EMI \ / \ / \ / 2950T-...

I have RME 3.4 and use the CSV file format for importing devices into CW2K. Due to a renaming scheme going on thru the network I will need to delete several devices per day from our CW2K servers. What is the CSV format for the Delete from File foun...

Hi all,i have the szenario below: Cat1(EMI) Cat2(EMI) ----------------------- --------------------- I 3550 I------I 3550 I ------------------------ ----------------...

I have a Catalyst 2950C switch running 12.1(13)EA1 code, connected via a dot1q trunk to a 2620-XM router, running 12.1(18). The router is routing between three different VLANs. From the switch, when I ping the default gateway (on the router) I will o...

I am trying to SPAN an entire VLAN to port on a 3524. I want to span all of the VLAN traffic in the domain to a port, not just local traffic. I don't see a way to do this as spanning a VLAN this way doesn't appear to be an option on 3524 ports? Is th...

I am wondering if it is possible to send start-stop records to two AAA servers at the same time. I need authentication to only go to one server, but need the CDR records for a specific billing process seperate from the customer AAA box.I seem unable...