Other Network Architecture Subjects

I have an issue where a single T1 line is overriding a mppp T1x2 line in my route table (see below). It appears the composite metric is higher on the multilink ppp circuit than the single T1. nhmnrtr7204-01#sh ip eigrp topoIP-EIGRP Topology Table for...

I have created Etherchannel on Cisco 3524 between port 1-2, 3-4, and 5-6 and they are connected to 3 Dell Servers.Server 1 (Dual Nic) connected to port 1-2Server 2 (Dual Nic) connected to port 3-4Server 3 (Dual Nic) connected to port 5-6The problem i...

hi, i'am a beeginer in cisco, i am preparing the exam of ccna, and i would like to know hwo to intercnect tow distant site via pstn( telephone).i have two cisco router (26.20) and 2 modem us robotics.thank you very mutch.

Hi! I asked this before but no helpful advice came up.I'm running C2600 with WIC-1ADSL module. It is connected to normal ISP providing end users (home users) five dynamic public IPs for five different hosts.Inside network is running on private 192.16...

We have approximately 250 routers across the USA, and all these routers were configured with no auto-summary (disabled). My question is, what could cause the auto-summary to be enabled without someone manually enabling auto-summary.

my company has a private routable address and a none routable address that we need to connect to the internetATM 3/0 204.60.0.0/30eth 1/0 172.0.0.0/28eth 2/0 192.168.1.0/24 how do i set nat to work for the 192 address and not the 172?

I have a 2610 router as my gateway. I want to block and ip range from passing through. I have been under a constant flow of MSSQL Command sig's and want to block the entire 61.0.0.0 network. What is the syntax for the access list. I have "access-list...

Hello all-->I want to pull bandwidth stats from the serial int on my publicly connected 2621. Any ideas on doing this automatically so I can log over a period of time. I don't want to purchase anything either.Any help is appreciated. -->jason

I am experiencing some bottlenecks in the networks. Atleast that is the way it is percieved. I am trying to prove that it is not the network and the problem relies elsewhere. I am looking for a good tool that will test the connection times to other r...

I recently activated syslog logging on my 806 DSL router and have noticed my virtual access interface drops at least once daily, it'll do it for a minute or so then comes back up. I notice mostly because I'll be on the web and all of a sudden I'll ...

I am trying to get OSPF working between my 2 Ascend MAX6000's and my 7206. Does anyone have any tips on how to make this work?Thanks,Mitchel

is there anyway to modify the upstream or downstream parimeters on the cable modem? or upload a custom/test DOCSIS via TFTP on the ethernet side? thanks!