Other Network Architecture Subjects

I have installed to my customer an gigastack deployed to four Catalyst.Two catalyst 3548 with software 12.0.5.3WC , one Catalyst 3524 with software 12.0.5XU and one Catalyst 3550 with 12.1.11E1.Because I see a lot of collisions on each ports gigabit ...

hei,I have 3 switch 2950T-24, each switch have 3 VLAN (VLAN A, VLAN B, and VLAN C), all switchs via 1000Base T port connected to 3550-12T. Can 3550-12T perform inter vlan routing, so all vlans can be communicated ?thank you for allthomas

Hello,I have a 1601 that was working fine and operational until I power cycled it last night. The unit turns on, the LEDs perform the self test, and then the System OK LED begins to flash slowly like normal. The OK LED then goes solid for about 3 s...

HI,Can any one tell me is their any aplication for checking the IOS which is downloded from cisco site. Although the tftp shows the file is sucessfully downloded.with the bytes size matching. such as CRC application.thanks

Hi,I have about 200 connections at corporate location. I am considering purchasing 6 Catalyst 3550 switches (5 live, 1 backup) to connect endusers. These units would be uplinked using the 3550-12G. However, someone questioned why the 3550 switches ...

I am working with a setup where two CM servers are deployed to manage half of the resources in the environment and a single RME server being synch'd by the two CM servers. My question is what is the best practice for handling the split environment? ...

Hello: I connect a Catalyst2924 to one Catalyst6506.there are 100 Vlans on the C6506 and just 4 vlans on C2924.As you know,there is limition on 64 vlans on c2924,so I want to use VTP Pruning to permit just the four vlans used on C2924 .I have a...

Could you show me similar Cisco has functions as below:Cisco 806 Broardband Router 4E, 1E, statefull firewall, Cisco 806 Series IOS IP PLUS. Use function is as follows:- Firewall-IP address allocation management (static/DHCP) for LAN-IP address allo...

Hello I have a new C2620XM with 8M flash and 32M Dram,the least requirement is to use Trunk(ISL or Dot1q).Can you give me advice on it ?I use software adversor and found the smallest DRAM is 40M.Do you Know a version can run on 32M DRAM,thank you v...

Hi all,I find that my 2950-24T (12.1(11)EA1) has "access-list" command in config mode and "ip access-group" in interface mode. So can I apply access-list in a fast ethernet interface? and How about 3550? I remember in 3550 manual cisco told us to use...

Cat 3550 - I am looking for the easiest way to give two individual ports priority access to the switching bus whenever data is present like you can with the SET PORT LEVEL for a Cat 2900. If possible, priority access to each other . All ports will ...

hello I want to know whether any ftfp server software(for example cisco tftp server) can act as the vmps tftp server thanksscorpions