Other Network Architecture Subjects

my 7200 router has been reloaded , after the reloading the MRTG didn't work smoothly into the fastethernet subinterface while it is working fine into the other interfaces.when i put show snmp i recieve 0 SNMP packet input and 32367 SNMP packet outp...

I have Cisco 2610 I am trying to connect to a Netopia R5100 over a point to point Frame relay. But, after about 30 minutes none of my hosts can connect to the other end. If I ping the remote ip address on the R5100, then my hosts can connect to the o...

Hi, I am using LMS 2.0 on WinNT 4.0. It was working fine from long time. but now I am not able to login in ciscoworks. When I am trying to connect through browser, I am not able to get login windows. JAVA is giving me following error:java.net.Connec...

Hi All,Is there any performance degradation for long routing table of a gate-way router? orWhat is the performance issue for long routing table on gate-way router?Thanksrichard

Please explain details of debug:L2TP: Result Code (2): Call Disconnected, refer to error msg Error Code (6) Vendor specific I'm have a 7200 and 7120 LNS connected to an ericsson tigris RAS

Today there is a guy ftp 1gig of data from the Internet and it slows down my network. How do I do bandwidth limiting on ftp traffic to 500kbps for both inbound and outbound? Thanks,

hii apologise if this is not the right forum...i am up against 3com in a deal for a customer who is planning on upgrading his Corebuilders. I am bidding Cat4500/Cat6500 and 3com is bidding their XRN technology. I dont know much about XRN but the cust...

As I understant about the explanation and configuration of Private-VLAN is that intervlan routing between vlan are no problem even if there are protected ports in different vlans. But I am looking the configuration of inter communication between same...

I have a 3524-XL switch running IOS 12.0(5.2)XU. The configuration register is set at 0xF. What does 0xF mean?

I need to place an order for some extra mounting hardware for 3500 switches, and 2650 routers. However, I haven't been able to find any part numbers, could someone point me towards the light?Thanks, Robert

I have a 3661 with a PRI port that connects to the LEC to provide voice in and out for my Call Manager. I also have another 3661 with an NM-8BU and 6 mica modems. Is it possible to allow analog modems to dialup through the PRI to the mica modems wi...

There are 2 sites,the central and the remote site,both are 3660 routers.There are 3 T1s going between them.The Third T1 always shows a serial interface up and line protocol down.When the T1 actually goes down,it comes back up only after rebooting the...

Few engineers claim that configuring servers' ports 10/100 half duplex instead of full duplex is a better design in Catalyst switches. Is it true? if it then why?Thanks

If I have a 10mbs VBR PVC configured on a DS-3 circuit, in theory can I get 20mbs throughput? If I have a user on each side of the ATM link each copying a 300MB file, 300MB inbound and 300MB outbound on the interface, and there is no other service v...