Hi, When using the "set qos policer " command in cat 6500 series,what is the best burst size that can be specificed,is it half the rate and erate value..Thanks
I just setup a 3550 and am trying to be able to telnet into it. I read the online documentation and setup the vlan1 with an ip address and default gateway. Now, I can't ping it or telnet into it. Is this the correct place to assign the ip address ...
Hi,Does anyone know the where the detailed explanation on each fields in the "Show controller serial " can be found ? I can't find it in the cisco web.There is a problem in one of the point-to-point router link as there is a slow incremental "overrun...
One customer is blaming that on a MSFC card the statistics shown on the show interface vlan output (in terms of received and transmitted packet) are not real.He doubts that what is shown there are really all frames received by this VLAN.For what I se...
In my nework there are two Cat4006 SUP3 switchs with a 48 port 10/100 module.I use Ciscoworks2000 LMS2.0.In Ciscoview,the appeared module and SuperEngine of one Cat4006 is blank,another is normal.Why?The following is the output of "show version" on...
Following is a debug of an PPPoe PAP authentication attempt between a Cisco 2610 connected to a ADSL modem. When attempting to logon using PAP the message dated "*Feb 28 22:55:09.474" where "choice:" is being send back to the router appears to be cau...
Does anyone know if UDLD will error disable both trunk ports in a channel if it notices a problem on one of the ports, or will it just disable the port that is having the problem?Thanks...
I have both at this time. Is RTM replacing TD completly, or will Cisco planning on suborting both? If it is a replacement, why the change?As a side note, I have had difficulty getting TD to archive reports. Is there a trick to get SQL or mySQL to...
How can I provide always one B channel for both Dialers and two B channels for one Dialer if necessary?Router1 interface BRI0 encapsulation ppp dialer pool-member 10 min-link 1 dialer pool-member 20 min-link 1 ! interface Dialer10 encapsulation ppp d...
Has anyone here configured LDA for a Cat 6500? I have a 6509 w/ MSFC...and I would like to use the Cat backplane to accelerate load balancing.Any suggestions?-->jason
ok, i am trying to set up a dmz with a 2950, and a nokia ip330... have had nokia box for (4) months, works great... trying to configure 2950 as: 192.168.1.254/24and 3rd interface on nokia as 192.168.1.1/24, but i can not get 2950 to talk to nokia box...
OK I need someon's help. I am trying to setup a DMZ. I have a Cisco 2621 Router that is connected to the WAN link via interface FastEthernet 0/0.I then have the interface FastEthernet 0/1 connected to my 192.168.1.X network.I tried to get a Fast Et...
Please How do I go about doing a network translation from ip address 192.168.3.1 to 194.168.2.1?This is so that when request is made for 194.168.2.1 it will be sent to 192.168.3.1.Thanks for your help.
I am running LMS 2.1 RME 3.4 and CM 3.2 on a WIN2K server. Ever sinceSP3 is installed, User Tracking was stucked on discovery non-stop.I did net stop crmdmgtd, run reinitdb script with -restore, run dbpasswd script to force a password for ani db, di...
