Other Network Architecture Subjects

Following is a debug of an PPPoe PAP authentication attempt between a Cisco 2610 connected to a ADSL modem. When attempting to logon using PAP the message dated "*Feb 28 22:55:09.474" where "choice:" is being send back to the router appears to be cau...

Does anyone know if UDLD will error disable both trunk ports in a channel if it notices a problem on one of the ports, or will it just disable the port that is having the problem?Thanks...

I have both at this time. Is RTM replacing TD completly, or will Cisco planning on suborting both? If it is a replacement, why the change?As a side note, I have had difficulty getting TD to archive reports. Is there a trick to get SQL or mySQL to...

How can I provide always one B channel for both Dialers and two B channels for one Dialer if necessary?Router1 interface BRI0 encapsulation ppp dialer pool-member 10 min-link 1 dialer pool-member 20 min-link 1 ! interface Dialer10 encapsulation ppp d...

Has anyone here configured LDA for a Cat 6500? I have a 6509 w/ MSFC...and I would like to use the Cat backplane to accelerate load balancing.Any suggestions?-->jason

ok, i am trying to set up a dmz with a 2950, and a nokia ip330... have had nokia box for (4) months, works great... trying to configure 2950 as: 192.168.1.254/24and 3rd interface on nokia as 192.168.1.1/24, but i can not get 2950 to talk to nokia box...

OK I need someon's help. I am trying to setup a DMZ. I have a Cisco 2621 Router that is connected to the WAN link via interface FastEthernet 0/0.I then have the interface FastEthernet 0/1 connected to my 192.168.1.X network.I tried to get a Fast Et...

Please How do I go about doing a network translation from ip address 192.168.3.1 to 194.168.2.1?This is so that when request is made for 194.168.2.1 it will be sent to 192.168.3.1.Thanks for your help.

I am running LMS 2.1 RME 3.4 and CM 3.2 on a WIN2K server. Ever sinceSP3 is installed, User Tracking was stucked on discovery non-stop.I did net stop crmdmgtd, run reinitdb script with -restore, run dbpasswd script to force a password for ani db, di...

Did a show interface on a FastEthernet port on a 7206 and got the following output for the queues:Output queue 0/40, 0 drops; input queue -145605/75, 0 dropsI am confused as to why the input queue size is a negative number. Any ideas?

Is it possible to have a 3550-12G Switch Monitor Layer 3 traffic on a layer 2 port. I know these switches are L3-4 aware and are L3 switches as well (enhanced code, which we are running). I am looking at a dropped packet issue and would like to debug...

service timestamps debug uptimeservice timestamps log uptimeservice password-encryptionno service tcp-small-serversno service udp-small-servers!hostname DSSacdpsb!enable password XXXXXusername Derbycimp password XXXXXXXX!no ip name-server!isdn switch...

I would like to hear what is the best solution for consoling to a router/switch via a notebook with no serial port. I know there are USB to DB9 adapters (see link below) but I have heard that there are issues with sending the BREAK signal with these....