Other Network Architecture Subjects

Hi, I have stange message that arrive on my RME 3.4 ,it refers at interfaces EOBC0/6.This is the message:(511) Router:CISCO CISCO Mib-II Poll IP_Interface Repaired Broken (324) 127.0.0.12 ifdescr(EOBC0/6)I've got to consider this message like an crit...

We are trying to determine what type of connection to use for a possible WAN node in China. With a VPN we are concerned with possible encryption laws. So I am wondering if anyone in this forum has experience with this, and what considerations we sh...

Hi all,We connected two 2620 routers over a 2 Mbps link. The interfaces we use are G.703 controllers. The line is unstructured. The IOS installed on these routers are 12.1(5)T12 IP Plus 3DES. The data are 3DES encrypted and went through a VPN tunnel....

Does anyone have some ideas or information on whether it is possible to installing different CW2K component on several servers and still have one initial user interface (a kind of portal) to access the different components/tools?

Hello,after a Server Reboot, i get the following ErrorFAIL Self Test Fail to query rme.DbVersion, Error: [Sybase][ODBC Driver]Unable to connect to database server: unable to start database engine Self Test Fail to query rme.SYSTABLE, Error: [Sybase][...

Anyone please suggest is there Cisco website available for giving guides on all Cisco products hardware specs such 3620 - how many WAN slot, NM slot, flash memory, DRAM and so on.

Hi, we are running the latest version of CW2K LMS bundle. We have set the system up onsite and all works OK. We are now trying to remotley manage the Network and we have a 2 Meg Leased line into it, which hits a Checkpoint Firewall. We can connect to...

What is the maximum acceptable level of collisions on an ethernet interface (running half dulpex) as a ratio of packets throughput?

Who can I deny telnet to my router?

I have a AS5248 with dual T1/PRI. We have a T1 PRI that is going to have only 12 lines working. I need to configure it that way....how? I have 11.3 ios

I accidentally erased my flash on a 1720 router. I have the IOS CD, and Ican xmodem the image to the router. After the image decrompresses, I caneven configure the router. However, when I reboot, I go back to the RoMmonscreen. I have my register set ...

I need the ability to have a 2948G-L3 perform Layer 2 VLANS, perform Inter-VLAN routing and HSRP for the Inter-VLAN routing. There will be a second 2948G-L3 for the HSRP partner. Is the config below correct and the best way to do this? Thanks.bridge ...

What the may defference of WS-6148-RJ45V & ws-6348-RJ45V ,because the listprice is defference..

I've got a client that changed the subnet mask of his class C network to 255.255.252.0. It was 255.255.255.0. The address range that we were using was 192.168.253.1 - 192.168.253.254. Now the client is trying to use the 192.168.252.1 - 192.168.255...