Other Network Architecture Subjects

I have a problem, i have this definition in my Switch : rmon alarm 4 lsystem.57.0 2 absolute rising-threshold 40 7 falling-threshold 30 8 owner adminrmon event 7 log trap netcenter description "Rising EventIndex for avgBusy1~%~" owner adminsnmp-serve...

In IPM, what does the minimum jitter value mean? Packets that have arrived earlier than expected? What does it mean? The documentation is incredibly unhelpful when it talks about this.

I installed Campus Manager in one Sun machine, i want the topology services can display my network topology. but i found that "network views"->"Layer 2 view" cannot find any devices, all devices is in "network view"-> "unconnected devices view", af...

I am running Ciscoworks2000 4th ed..Using RME ver3.3...I installed the latest IDU (RME 3.3) and continue to get these bogus alerts.......Can I installed RME34.IDU.v2?Then had can I check to make sure it has been installed?

I would like to check the bandwidth statistics (latency, kb/s, # of packets...) on my routers' serial and ethernet interfaces. I figure I need some kind of SNMP software and some configuration changes to my routers but I don't know where to start. ...

In my network I have various vlans configured. Inter-vlan routing is done by a 2948g-l3. The switch is connected to a router which in turn is connected to the wan. Is it correct to create 2 default routes in my router or should I create a default rou...

Situation:Several different TCP-based, priorized Applications are guaranteed Bandwidth on the Router like Application Nr.1, 30 %, Application Nr.2, 50 % and Application Nr.3, 20 %. Expected Bandwidth [bps] can be calculated according to the defined B...

I'm having a conversation with a co-worker over whether a stand alone network with only one OSPF area needed MUST use area 0 or not. Can anyone point me to a place that will address this question for us?

We have installed a brand new LMS 2.1 on an IBM e-series 345 high end box with the 2GHz processor and 2GB of memory. I am running W2K server OS on it. The installation went without a hitch, however when I started configuring different apps from my IE...

hey folks...my client has a requirement to tunnel CLNS traffic over and IP backbone..i was planning to use GRE tunnels to perform this but noticed another encapsulation option...'eon' a standard for carrying CLNP over IP networks.Further investigatio...

Hi,How many secondary addresses can I configure on the same VLAN on a Catalyst 4006 with Supervisor Engine III?Thanks,Leonardo

A B +-------+ +-----------+ ! 1 -------------------------! 1 +---------+ +-...

Is terminal history buffer size enabled on all cisco routers by default...Is it the same for 2500 routers because the "up arrow" feature is not working on my C2500-JOS56I-L Routers. I artempted to change it with the terminal history buffer size comma...