Other Network Architecture Subjects

"RAM Access Frame from non-ram access port"I am receiving the following error message on a C3500 and I cannot locate a reference to it on the Cisco Web Site. Any suggestions?

I have a 1602 (non-r) that is giving me an error on boot up and I cannot seem to find any reference to the error on cisco.com or anywhere else.The bootup screen looks like:System Bootstrap, Version 11.1(10)AA, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)C...

We have a pair of 6500s doing HSRP on a number of VLANs. We use RIP as a routing protocol and find that the routers exchange RIP routes on each VLAN they both have IP addresses on. In the case of HSRP interfaces the two permanent addresses exchange R...

have a DSL broadband connection using PPPoE encapsulation and use a netgear router cabled from the Netgear WAN port to the Ethernet port of the cable modem to handle the authentication to my ISP. Would it be possible with any of the IOS versions to ...

Hi, thereIf my router is enabled with IARP, do I still have to use the commandframe-relay interface-dlci 325 (where 325 is the local DLCI of my router)to associate my serial interface with the dlci number 325 in a multipoint configuration environme...

I am a Cisco academy instructor at Sunny Hills Academy teaching Cisco CCNA. I want to ask this questions for my class at Cisco Academy Program in Fullerton CA.1-what is the maximum # of the outgoing links in a backbone router?in other words, when a ...

hi,is it possible to use route-map to set the ip-prec-bit in the following way:route-map set_ip_prec permit 10 match ip address voip set ip precedence critical!route-map set_ip_prec permit 20 match ip address premium set ip precedence flash-override!...

I have a Cat 6509 which has Supervisor Engine 1(5.3) and MSFC 1(12.0.7).In normal state, The average cpu utilization of MSFC is 1%.but Suddenly MSFC was hanged after the utilization recorded 100 %.I don't know the reason why the utilization record...

My 3550 Switch shows a "show process cpu" result like below.Please pay attention to the 33th process and its utilization.LGT_MAIN_3550_B# sh proc cCPU utilization for five seconds: 100%/0%; one minute: 99%; five minutes: 99% PID Runtime(ms) Invoked...

Can somone tell me why I am getting the following error message on the console: %Error Opening tftp://255.255.255.255/cisconet.cfg(Timed Out)I have no entry to boot from tftp server in the config file at all.Thanks

I am trying to save router config using TFTP. Server is on my central site. And I have lots of timeouts. I thing that problem is in face that from IP address used for transfer is IP address of serial interface on my router and not of ethernet interfa...

Netware has a transport layer service similar to tcp called SPX,but no service similar to UDP.Applications requiring connectionless service directly access the connectionless IPX at the network layer.What purpose does UDP serve by providing a connect...

I have two sites on different VTP domains. Site A has a dsl router that site B needs to access over the WAN/T1. I have plugged the one of dsl router ports to a cisco port and assigned a vlan X to that port without a default gateway. I can access the ...

Hi Eveyone , i am stuck with an issue of eigrp metric change, it goes like this:i have servers based in HUB , HUB & Spoke are connected through theLeased line & VSAT , eigrp is running between them .Now we want to send the traffic from the server1 &...