Other Network Architecture Subjects

I'm trying to export device from CW2K to RTM 1.3I was reading on RTM FAQ :http://www.cisco.com/en/US/products/sw/cscowork/ps2803/products_qanda_item09186a0080094b24.shtml#importIt says "Caution: To avoid undesirable result, only use the Import utilit...

Hi How do i configure SNMP trap on my router ?I want all trap messages to recive on my server.What is OID ?

I want to be able to dial into a 1605 router. Can this be done via the console port as there is setting's there regarding a modem.Hope someone can point me in the right direction or simply tell me it can't be done!!Best regards,Darren.

Hi,I have put a route map for a transparent http proxy on two Cat 5509s. Works fine. Unfortunately it breaks NFS altough NFS should not go through the Acls.IOS is 11.3(6)WA4(9).Route map looks like this:route-map proxination permit 10 match ip addres...

hello, the command for static ip route says" next hop or exit interface".when do we use the exit interface?can we not use it in lan?is it only used in wan?can u answer my queries? smita.

Hi everybody,"Clear counters" IOS command reset only some MIB variable values. For example, it resets cfrCircuitDEins (.1.3.6.1.4.1.9.9.49.1.2.1.1.1) but it doesn't reset frCircuitReceivedFrames (.1.3.6.1.2.1.10.32.2.1.8) so if we compare both values...

My apologies for possibly placing this thread in the wrong forum, but it covers both ATM and LAN routing. I have a CAT5500 with integrated LANE card and ASP, connecting across a 34MB ATM link to a LS-1010, connecting to a 4700 series router. There is...

HelloAll VRRP Documents refer to Mac Addr in hex 0000.05e00.00xx. Is this so used with a Multicast Vendor Code but without leading 01 bit (MAC Address Multicast indicator-switch)or is this just wrong description and in true is 0100.5e00.00xx used.The...

Hi, I have two Remote Sites with RouterB (1720) and RouterC (1720) respectively bothe will call to the HQ RouterA (2620) as required (DDR).Q1. If I were to configure RouterA to be able to call to RouterB or RouterC as well (i.e. both way calling), do...

Would like to ask some ideas if there's an interoperability issues between a Cat 2948G and Cat 3550 linking using 1000Base-SX port/module with default config only. The two switches will not connect even if it's connected through a 2m fiber SC patchco...

The web site said the minimum version is 7.2(2). I want to know which version is good if you have experience on it.Thanks

I would understand which is the trick (if exists) to aggregate a couple of these interface to see both a single interface. I have been told that provider assigns only one PVC but how can I split it (from config point of view) between two physical int...

Hi Group, I want to know if anybody can help me! I have a client with a big new MLS network that includes 2X6506 at core, 12X 3550-12 G at distribution and 159 2924-2g at the access. It is a Gbits Backbone .This client want to bridge all the IPX and...

Ok In theory it can be done. has any one ever done this? Im very keen to try. Any help on where to start would be great!

Hello,I have a hub and spoke topology with Frame Relay. My hub is connected to the Frame relay operator with an E3 (34M) link. I have implemented Frame Relay Traffic shaping with Priority Queueing on all Frame relay pvc (with frame-relay class).My pr...