When aggressive UDLD disables a port(err disable) will it automatically bring the link back up when the problem is fixed or do you have to do a udld reset.
One of our modem servers (Lucent Max) is sending route information for 0.0.0.0/0 and 10.0.0.0/8 via OSPF. Our core router (Cisco 7507 w/IOS 12.2.7a) accepts them even though these are not on the OSPF network list. Is there a way to force the router t...
I am trying to setup a Dell 5224 to trunk to a Cisco 3550 using 802.1Q. The 3550 is our core device used to connect 5500s using ISL to route between the VLans. I trying to add the Dell switch and must use 802.1Q encap. Native Vlan is vlan 1. With 80...
We have a problem about X25 configuration. We are using PAD connections on an X25 network. Every PAD connection uses about 1k buffer memory. Although the PAD connection is terminated, the buffer is not freed.So after 17000 PAD connections, we get "%...
Dear Sir! My colleague attempted to pass CCIE R/S lab a few time ago in San Paulo, Brazil. There are IOS 12.1.5T - deffered release!!! only in all of routers (except 3550, of course). And there were some mistakes in 12.1.5T, because some portion of e...
Just intstallED CD ONE of CWLMS-2.1, I can lauch CISOCVIEW, but I couldn't view any cisco device(router or switch), I always got a ciscoview error:Resulting class definition does not exist on server! com.cisco.nm.cw.devpkgs.CatQdm.DescriptorProbable...
Hi,I tried to add a switch in the RTM server. I filled in the correct info (systemname, ip, snmp community RO and RW string,...). I didn't specify a switch type (autodetect). But I got an error message after pressing the 'add' button, specifying that...
Hi there !I would like to achieve that no Host Routes will be redistributed in OSPF if any Dial-UP Client connects.The Router is a Auton. System Boundary Router as it also redistributes Static Routes.So I tried to configure a "summary address" for th...
Hello,I need to monitor internet access at my company.I just need the internet bandwidth per port utilization, contents are not important.This is our simple topology:Internet----2600Router-------PIX506-------2x Catalyst 3524XLI can only access the 2...
We have a 2620 at the main site and (4) 1604s at remote sites. The 1604s are programmed to use dialer-map and sense when traffic for the other side is interesting and then create a connection. The ISDN lines are not metered and are flat rate. Can som...
HI AllWe have a WAN of a round forty routers with backup isdn into a pri at the central site. My routing protocol is eigrp. On my WAN links, I use IP address's with 30 bit masks, and on each remote router, I configure a dialer to dial into the centra...
Dear all,I configured VWIC-2MFT-E1 as ISDN PRI with channel group as shown below.But I get the following error:%E1T1_MODULE-3-LINEFLAP: Interface Serial0/0:0 receiving excessive errored packetsMy question is can I use this card for channalised E1 or ...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
.jpg "VIP Community Legend"){kind=icon}
