Other Network Architecture Subjects

If I have a static route as follows :-ip route 10.1.9.0 255.255.255.192 Ethernet0/0and this network is not directly connected (say its a route for a NAT pool)then I have router eigrp 925network 10.0.0.0Does this network automatically get redistribute...

hiwhere can i find technical documentations for WS-X4019 blade ?thanks in advanceJYP

Is it possible to configure all the ports on a switch at the same time or do they have to be configured one by one. I would like to change the duplex setting on all ports to Full instead of Auto. If this can be done what is the correct syntax?Thank...

I've got a 7200 router with two 10/100 int's on the inside and a T1 to the Internet. I use my public IP addresses internally so I am not NAT-ing. I want to bring up the 2nd 10/100 inside interface and set up a 192.168.0.0 subnet and have that NAT'd o...

Hello Once Again.I'm wondering if this will work.On my 1720 I have a Dial-up ISDN line configured as a DDR backup for my Serial line (See Previous Post).All works well when I take the serial line down, the ISDN dials up the ISP and connects. I can pi...

Hello,I just turned up a DS3 this morming and need some help configuring BGP. The DS3 is replacing 3 T1's. I will be keeping one T1 for failover. The problem I am having is that right now almost all outbound traffic is going over the T1's I will be d...

Does anyone have problems with discoveries starting and just stopping right in the middle? Also does anyone know if Campus Manager is going to support MSFC2's with 12.1(13)E code?

I want to order the Dell 3248 and connect it via fiber to a GBIC port on a 6500. Has anyone done this yet? Also, if you have, do you happen to be using 802.1q for your VLAN setup. We havent got the time or money to test so I am hoping someone can t...

I have a 2511 RJ that we are setting up. We are using TACACS+. Will be moving to RADIUS later. The problem is that when a user dial up, they get a windows 733 error, babling about inability to get a negotiated protocol.NAS config is as follows:ver...

I am looking for some direction / information on QoS configuration for Packet over Sonet Interfaces on the flexwan module for the 6509 catalyst. I have not seen much in the documentation.thanksDave

Hi,I am trying to connect two 1600's together using PPP over X25 on ISDN dchannel using the AODI method. The following two configs are the client and server running configs of each router (client first). I keep getting this error (Pending on AODI dia...

Are any MIB variables for measuring the traffic if CQ & PQ queues

Every time the CW2K server is restarted, Campus Manager starts a discovery and brings down the serial links of our network for about 20 sec. On analysis, we found that the links may not actually reset but that the ANI server is sending massive amount...

I have one Cisco 4500 with 6 Ethernet, and 8 serial port. It has only 32mb dram. (2*16mb). Now I wan to run BGP in this router. So for that I need min of 128mb memory. It has only two memory slots. Is it possible to upgrade that to 128mb. Will it tak...