Other Network Architecture Subjects

the catalyst 3524's flash system had destroyed and cannot normal run , I want to copy the new iso to 3524's flash, pls help me .thanks2002/11/10

After upgrading software, "show logging" no longer lists the pagp facility and there are no more "%PAGP-5-PORTFROMSTP:Port 1/3 left bridge port 1/3" messages in the log...

I need connect a sever with two fiber NIC to a catalyst 6500.I want to work a 2 GB with load balancing. Is this posibble wtih fiberchannel ?How can I configurate the catalyst ?Regards

Are there any performance stats for the 827?Im wanting to run one for say 10 clients all using NAT and I need to know if I'll be able to fully utilise the 2mb ADSL pipe we are getting, or whether the overhead of NAT would be a problem or not.I know i...

I'm trying to develop a test scenario for pass/fail testing of some questionable GBICs. We've had a series of both complete and partial (one phase of three) power failures, and some of the links did not come up when power was restored. My test-bed ...

I get the error " error -14 open device bootflash failed (no more file records)" when I type in the command dir bootflash: on a Catalyst 4006. I am in the process of installing the CWI and need info contained in the bootflash. What would this error ...

This may be a little lengthy but hopefully someone can point me in the right direction. Scenario: I am located at a facility that has a point to point frame relay line into a customer site with a FTP Server that I need access to. I actually target...

I am using CiscoWorks 2000 and I need to get baselines for our network.What can I take and what tools can I use for them within the CiscoWorks 2000. We have a CiscoProbe attached to 2 core Switches only and the others are edge switches attached to th...

When we would like to print a network graph , the first third is not printed. Only the two thirds below is printed. All printer parameters was verified and the behavior is the same with an other printer. I didn't find a bug on this problem. Did you h...

I want to install lan Management 2.1 for window/Solaris on HP-UX 11.X , OpenView.So I read Release of LME2.1 for Window/Solaris, that is only Support window and solaris Platform.But My Customer want to Install LME2.1 for window/Solaris on HP-UX ...

Hi,I have a Cisco Catalyst 2980G configured with several primary VLANs and additional community VLANs. This configuration is used in conjunction with a Cisco PIX for a 'cheap' but secure DMZ-solution. I run version 6.3.7 of CatOS on the Catalyst.I ha...

Hello, Sorry about, but I have tried to find out the ordering number for a defective Fan-assembly in a cat8540 (13Slots) no way. Could you give me a link to find this out.Thanks Ruedi

I am having a problem connecting a c2950 through a single vlan port to another c2950 port in native vlan (1).I have one c2950 in which i changed the managment vlan to 10. I changed one port on that switch to vlan 10 (non trunk) and connected it to...

Hi, I need to get the CHASSIS serial number from approximately 50 remote sites, and other than going to look at the back of all the routers is there an IOS cmd to do this - I can't find one anywhere?!?!? Cheers for someones help, PS. "show version" o...