Other Network Architecture Subjects

Hi anyone pls suggest the URL for sample configuration for a site with router to receive the ISDN DDR dial-in from MULTIPLE remote sites and how to configure the routing tables to cater for the for these remote sites.Please help out .

Hi,Does any body have Idea about making rip converge faster than what it takes time now, by some hook or crook. Triggered or any such methods. Now I very well know that for faster convergence I need to use EIGRP or OSPF. But I don't have option other...

Is it possible to configre Neighbor x.x.x.x under router rip convert RIP broadcast to point-to-point unicast. and Then configure acces-list to allow UDP 520 (RIP) to pass through PIX ( like BGP TCP 179 pass through PIX) . so that dynamic routing upd...

I have an E1 PRI dual card in a 3620 router.The two controller interfaces, E1 1/0 & E1 1/1, are grouped to 1 rotary group.These, in turn are grouped to 'interface dialer 1'.Ok, the problem I'm having is a simple one. When configuring the static route...

I am confused with the in and out command in access-group access-group 100 in/out I read in an aritcle that IN means the data comming to our network and in that case the source will be from the internet and the destination will be system behind my ne...

I have a school that is 100% Macs. I am using a Cisco 2600 series router for the LAN. It is routing IP only and also running NAT internet services. My question is should appletalk routing be on in my router and also would creating multiple zones help...

I have a 6509 at the core & 3500 switches at the closets. Port security is on all ports & is configured to shut down when a different mac is detected. I have 2 users that are having a problem where 'rogue' mac addresses shut them down. They both have...

We are currently running Cisco Works LAN Managment Version 1.2 (CD Release 5).We have just purchased the 10-Device VMS 2.0 module and I am wondering if there is a particular order to install this set of tools.There is older versions of CD ONE & RME i...

If I configure neighbor x.x.x.x under Router Rip routing process, does this command automatically disable this router send RIP broadcast traffic out to its interfaces?

I would like to get the cef adjacency detail table via snmp. Anyone know whatmib to use to get this? I really want the arp table but there are lots or warnings about using the ipNetToMediaTable.Thanks

I added a 16MB flash simm to a 3640 router. I left the original 4MB simm in slot 0. When rebooting the router, I was dropped into ROMMON. Why wasn't the router able to locate and load the original IOS? Does this always happen when adding flash me...

Hi.Is it possible to use "access-list xxx permit ipinip hostA hostB" where hostA is connected to hostB over an standard tunnel interface (that is tunnel over an atm point to point) The goal is to use the access-list in combination with "traffic-shape...