Other Network Architecture Subjects

hello allIs there a way to summarize within an area. Let's say i have an ABR R0 that's connected to area 0 and area 1. There are two more routers in area 1, R1 and R2. R1 have networks 10.1.0.0/16 and R2 have 10.1.16.0/16. Is there a way to summari...

I have enabled jumbo frames on an entire vlan in my 6509, yet when I perform the "show vlan" command it displays the mtu size of 1500. If I go into session 15 and perform the "show int vlan 10" command it shows the mtu size of 9216. Why dosen't it...

Hi AllIs there a way that you can configure a router not to hang up an ISDN call after a specific time period? We have an outdoor extension that we use for our ISDN connection - we don't pay for the phone calls - so I want the router to be online at ...

Having trouble getting ssh configured on a 6509. It seems to configure ok, but I am unable to connect to the switch. How do you get local authentication to work?

I have a 2mb circuit i have a backup ISDN currently use a higher metric route for the isdn to fire up when the 2mb line goes down have a tunnel configured and have routes for the tunnel interface now this doesnt have any metric routes its plain stati...

at present the set up is :256K cct ------MUX-------IN -------OUT------(4) RJ45 VOICE PORTS.FROM OUT :wan connection to Cisco 1603 router.what the customer wants is:maintain the voice mux.can I replace the 1603 ,with 2612.? will the mux need to be co...

HiWe are looking at a case where we have high speed access to a WAN (DS3), but as soon as we use more than 2mbps we are charged extra. We would like to setup some sort of traffic shaping that is based on date and time. What we are looking for is to l...

Hi,Which setting at the css11150 I have to configure that I could managing the css11150 with rme3.3I've have already upgrade the rme3.3 with the newest idu. So I think I"ve made a mistake with the css11150 configurationBest regardsHilde

I recently attached 2 Win2K servers via a hub attached to a cat4000. Servers share a "virtual" IP. When testing I ran a ping to the virtual IP, and received two responses back. When the ping was stopped, I would see something like "10 requests sent...

I want to connect a 2924C 10/100FX ports to a 3524 GBIC port. Is it possible, if yes how?

I have cisco 2501 routers but am finding that the serial interfaces are failing. Is ther any way to test the serial interfaces to make sure they work besides trying to connect it to an actual circuit? I know you can do the route to router using a D...

We are planning to replace a few servers within our network, and I am trying to configure our Catalyst 6009 to use NAT to translate the target IP address to the IP addresses to the new servers. But I also need to be able to connect to the new servers...

I have two 7507 with this configuration:Cisco Internetwork Operating System SoftwareIOS (tm) RSP Software (RSP-JSV-M), Version 12.2(1), RELEASE SOFTWARE (fc2)Copyright (c) 1986-2001 by cisco Systems, Inc.Compiled Fri 27-Apr-01 12:15 by cmongImage tex...

The document from CISCO stated that Campus Manager version 3.2 version support 7401 PE router in topology only. There is still no support for user-tracking. We noticed that the users' IP addresses are still not present in the user-tracking.Would appr...

We have a 6509 running in native IOS mode that will spontaneously lose all of its OSPF and BGP routes. A 'show ip route' reveals all of the directly connected subnets (which are not reachable) and no other routes. The only solution to the problem i...