Have a Cat 5K that keeps rebooting inexplicably. While working that issue, I tried to look at the logs and can't get a reboot time. Cleared and Disabled all NTP settings. Tried to manually set date and time and all I get is 0 2000 00:00:00 . Not ...
We are implimenting RAS solution CISCO 26XX router with CISCO Secure ACS software.We need to have dial-back option on to a client specified telephone number (dynamically).What is the client software that can be used to achieve this ?
I need to set up a router (Cisco 2611) that can handle the ethernet output from a cable modem. Is it possible to setup dynamic IP addressing on the ethernet port for the router to accept the IP given by the Cable company?any help is appreciated.than...
Having some trouble with the setup of a Local Director 417 using http probes to test the functionality of an underlying database.The symptoms are as follows:2 real servers and 1 virtual. Http-probes sent with a 20 second interval. If one real server ...
I wondering if anybody else has seen the symptoms I've seen below:The symptoms we see are intermittent chronic slowdowns and connectivityfailures on the LAN, which seem to start and stop for no apparent reason.Logging on to the switch to view errors ...
I have 2924-XL series switches running 12.0(5)XU catos code. Is it possible to configure a loopback0 on these switches? Setting the snmp logging-source as loopback0 returns the message "Loopback0 not configured", but it then accepts the command. T...
HiWe have some problems dialing in remotely.Here are some debug:Any ideas?6d13h: ISDN BR1/0: Recvd MPH_IIC_IND from L16d13h: ISDN BR1/0: L1 is IF_ACTIVE6d13h: ISDN BR1/0 EVENT: isdn_sw_cstate: State = 4, Old State = 46d13h: ISDN BR1/0: Incoming call ...
I have lost all info for Cisco 1700 Router. IP address, host name, and password. Due to lighting strike need to get into router to check all info. Please help.
I have 8 catalyst 4006 Sup II (distribution) and 2 catalyst 6506 in the core. One of the catalyst 4006 had the following error "portDeviceStatusChange: no malloc for pwrDevMsg!" - could not telnet to the device but could ping the device. When we conn...
Hi,In an OSPF configuration, is it improper to have "redistribute connected subnets" AND a "network x.x.x.x" statement for a locally attached subnet ?I ask because:In my backbone area, I am getting a type 3 LSA from my ABRs for a certain subnet in a ...
I have enable PBR on one of my interfaces of 7513.which decide on basis of source IP block and chosse next hop. My question is what will happen if next hop is unavialable (down).will it go to alternate hop as decided by BGP.( I am running BGP, OSPF i...
Hi all, I am having multiple internet providers and running BGP with all of them. Traceroute packets are ping packets with incrementing TTL value. I can know the forward path from my client to the destination i.e ping request path. But ...
I am new to Cisco command line, so please excuse the basic question. I am working with a Cisco 2620 w/ IOS 12.1. I want to configure a static (default) route. I have tried doing so using the IP Route command, but when I do a SHOW IP ROUTE, it doe...
