Other Network Architecture Subjects

Does the Supervisor III in the 4006 switch support NAT

Hi all,Any ideas as to where I could find some good resources on how to carry IPv4 inside of a IPv6 network? Or, as well, maybe doing IPv4-to-IPv6-to-IPv4 translation. I am curious about how one could build a 100% IPv6 network, and yet still carry th...

Is there a way to copy a multiline banner file (that contains the set banner motd # # command) via "copy tftp config" such that there are no spaces between the rows? Is there a way of inserting a <CR> in the multiline banner file ? Everytime I copy ...

Can anyone help with this probably pathetic question? I have dial in users logging on with local cached profiles. They are authenticated by the router. I am unable to see their computer on the network using "Remote Control" software. This uses udp pa...

I have two routers A and B connected by serial interface. A and B has users who are mobile and move between lans...When users move, their TCP IP settings shudnt be changed.....A and B shud be configured to reflect this... All helps are welcome.Thanks

Hello We have updated on the cat6509 with MSFC2 the IOS on the MSFC from 12.1(8a)E5 to 12.1(8b)E10. After the boot of the Switch we had problems to get routing updates from the neighbor. The Status of the ospf neighbor was o.k. and also we saw the we...

Greetings,I have two major areas of my network. The core area consists of 2 3660s. One 3660 has 3 host frame T1s (15 PVCs total) and 2 PTP T1s (8 remote T1s coming in on these 2). This is the bulk of our traffic. The other 3660 is our edge router wit...

Dear sirs,We would like to know what`s the right way to add remarks or comments to our saved configuration in NVRAM. In others words, we wanto to remark each part of our configuration in our startup config.Is there exist any command to do it? or We h...

In viewing my Utilization Stastic Report on my 1900 I see "received" "forward" and "transmit".Received must mean frames received by the port, Forwarded must mean frames forwarded ny the port.So what does transmit refer to? Cant seem to fund an answer...

Is there any way to stop the telnet daemon on a 1605 with IOS 12.0.(4)T all together?? I have removed the vty password, but when you run a port scan on the serial interface, it still shows that telnet is listening. Can this be done or should I just...

Dear Sirs,I would like to know if I can set a router 7500 to star a route-map at a time I can Select, for example, Could I start a route-map at 21:00 everyday and stop it 3 hours later?Is there another process for doing this?thanks in advance.Carlos.

Could I connect 50 GBIC-ZX in one Catalyst 6509 (3 x 16-port GE module)? Any safety problem? If no, how many switches should I use ?

(1) I have a 3620 router with 3 ethernet ports meant for internal server routing purpose, say I have a subnetA (Class A) network , subnetB(Class B) network and subnetC(Class C) network at which each network is connected to each individual ethernet po...

the warnings are link this;SLOT 6:Jun 14 11:56:54.996 cst: %LC-6-PSARESTOREUCODE: Activated PSA VANILLA ucode.

We currently have two site connected together via Frame Relay (2500 routers). We installed Netware 6 pure IP (No IPX) Server/Tree at one location. When we try to install a Netware 6 server at the second location I am not able see the Netware Tree....