Other Network Architecture Subjects

Hi AllI have a 3640 with a 4 port bri module at the central site and a 2500 at the remote. I am using dialer profiles on both routers and am dialing into the 3640 from the 2500 and then wish to initiate call back to the 2500. When I try this it just ...

When configuring "router on a stick" or Inter Vlan Routing between a router and a Ethernet switch is the Native VLAN required for dot1q trunking? Is the Native Vlan required for all trunk links between a router and switch. What's the purpose of cre...

will a 3620 router with a second ethernet module be able to route ethernet connections from cable modems.

It there a way to make CW2000 not hide community strings while viewing a configuration with the Device Configuration Viewer in RME?

I have a switch with 100Megabit port, but I need a conection between two switchs directly connected at 400Megabits. Could I use these two switches connected through two ports, I mean, data flow should pass between these two switchs through these two ...

I would like to perform bandwidth throttling in Cisco LAN swtich on different ethernet ports. Which cisco catalyst series can perform bandwidth throttling in a cost effective manner.ThanksAmir

is there any mib variable to display access-lists?We need a way to get (display) access-lists through snmp queries if possible.

Hi there, here is my situation. I have two 1720 routers and my company wish to route them to a single point entry. here is a simple graphFirewall | | |1720A-------------------1720Bthey wish to route 1720b through firewall out to the inter...

We have to adapt OpenView NNM to prpoerly recognise Cisco devices using HSRP. I've about some difficulties with that. Would anyone know about special pitfalls, things to do or not to do?ThanxGeorg

Hi all,I am sitting with a bit of a delema. What would be the cheapest possible way to achieve the following in a way that there is NO third party carries involved (i.e. the information never crosses on any other network - this is 100% self owned an...

hello guy i need your helbthis is my config. on one site WL19 the controller is alredy up but on the Mue1 down may i check this with telco or is somthing missing on my configurationThanksHostname backup_WL19isdn switch-type primary-net5controller E1 ...

Anybody out there have any recommendations for a Windows based (2000 preferred) syslogd?Used KIWI - about all it lacks (or I'm missing something) is an export to HTML.Appreciate any advice.

Having routers that do not have a calendar - I somehow need to make sure my routers keep proper time. I've been pointed to NTP. Routers being used are 36xx and 26xx. What I thought I would do is run ntp master on our central router (point to point...

I have a router on which i configured PPP multilink on its 2 serials: i would like to configure a backup with some floating routes.The problem is that the gateway for the current routes is the address of the loopback (which is also the adresse on th...

Does anyone have any information on Cisco's progress with UPnP and NAT Traversal? I am particularly interested in finding out if any Enterprise Level routers have this technology embedded in the ios.Any pointers in any direction with regards to UPnP...