Other Network Architecture Subjects

Hi I have just purchased many WS-C2950C-24 switches and am having problems with inter-vlan routing. I have created 3 vlans, vlans 1, 2, & 3 on 7 of these switches. On each vlan, devices on the same vlan can ping each other and the default gateway whi...

Hello,I have some trouble to configure L2TP tunnel between a MAX and a cisco router.The MAX is LAC and the cisco router is the LAC, when the MAX send the SSCRQ to the router, i see on the router the below debug message :Jun 12 09:21:35.375: L2TP: Cou...

I have LMS installed with Cisco view - is there any security issues wrt to cisco view i.e. if I put a sniffer on the port - will I be able to see passwords etc With reference to HTTP - can we configure HTTPS on the switches ? Customer wants security ...

Hi AllJust a quick question ... ive always left vlan 1 as the management vlan but also put pc's and servers on that network as there has never been a need for multiple vlans. How important is it to keep general network traffic off the management vlan...

Does somebody indicate me an document on CCO about disaster recovery IOS for RP on Catalyst 8540 CSR?ThanksLorenzo

how do I redirect traffic destined to Mailserver port 25 to traffic filter without ssg.4700 router ios 11.2.

My customer wants to enable Appletalk routing on his router. They don't have it at the moment and all their Mac are on VLAN1. However, after enabling Appletalk routing on VLAN1 and two other VLANs(no MAC on these VLANs yet), some printers and server...

I am using 3 Vlans on a C3524 Switch via two bridging 1601's to connect a remote site to the CO. The vlans are 2,6 and 7. Vlans 2 and 6 are the untagged vlans, with tagging on Vlan 7.The problem I have is users on vlan 7 can get our local intranet an...

Would like to forward DHCP and BOOTP broadcasts (not turn the broadcast into a unicast) to a specific subnet on our WAN. This gives us the flexibility to change our DHCP servers without having to change router configs (in our case anyway). Example:...

Hello,I cannot find information about the pin configuration for the WIC-1DSU-T1 card. Does anyone know or can point me to where I can find what pins the module is looking for RX Tip, RX Ring, TX Tip, and TX Ring. I am assuming it's pins 1,2,4, and ...

Hi, Is it possible to map the bandwidth usage of a PVC with Wan Manager? It looks like I can 'limit' the bandwith with Connection manager but I cannot see a method of displaying usage. We'd like a graph to show the customers. TIA, Tim

Hi, I have a question regarding the new addition of gateway option in distribute list which is there in IOS 12.2(T). The Cli capture in 12000 series is as shown below:C12000(config-router)#distribute-list ? <1-199> IP access list number <13...

Could someone please tell me the difference for these? What does it realy mean when someone says " You can perform a soft loop". Any info would be great regarding this hard/soft loops.

12.2(4)Tmy configuration refer to:http://www.cisco.com/warp/public/794/wicadsl_pppoe_client.htmlhttp://www.cisco.com/warp/public/794/router_mtu.htmlwhen I change mtu on pc,everything is ok.I wonder if there is any other way that need not to change mt...

In a IGMP snooping/CGMP mixed VLAN, is there anyway to suppress the IGMP report/CGMP join floods that occur every 60 seconds?