Campus Manager 3.1 does not support and therefore recognise 2950 switches, as these are now being commonly deployed in switched networks is there any workaround or patch available to rectify this?ThanksNick
hello,i want to upgrade the feature of my router (1720) from the cisco 2600 using a 12.2(5d) version and ;flash:c2600-i-mz.122-5d.bin. it's possible?and if the 1720 platform support this version ?any help?
Hi, Here is what I have setup in the lab and for some reason I don't get BGP reflected routes as best route in the route-reflector-client's routing table. I know it has to do with OSPF. If I use RIP the same routes appear as the best routes. Any idea...
Hi,I am evaluating a network running frame relay running on star topology and currently running EIGRP. customer wants to move to OSPF , while i feel that EIGRP is better for its speed and convergence.Is there any document which details the comparison...
I have a customer who has a 1720 with wic1 connected Frame to Sprint Using Public address set 1, If that fails there is a 2nd wic with an ISDN bri connected to ISP 2, I can get the ISDN to failover the Frame connection using weighted statics to eac...
Compared to other questions, mine seems a bit "juvenile," but here goes anyway.I have two 1720 routers connected to each other by two Point-to-Point T1s. I'll call them router 'A' and router 'B'. Router 'C' is a cheap-o DSL router (soon to be a new...
I am using cw2k (NT) version with RME 3.1 bundled. When I used software management to add or distribute IOS image of routers and swithces, the following error message showed:Uploading image bootflash:c4500-boot-mz.113-8 from 10.10.10.1 Start time: 1...
I was wondering if there is a command line interface to the Netflow analyser product that I could use to get information out of netflow. and if there isn't if anyone know of some free tools to look at the data?thank you.
I need to limit the amount of bandwidht 256K that a single IP can receive or transmit through our 7200 to the internet. Would the best way be to configure an extended IP access-list and apply a rate limit to interface. access-list 101 permit ip host ...
Hi All,We happened to observe that when we enable tag in our backbone, the gre customers face issues with respect to browsing. It becomes very inconsistent. We have made mtu as 1500. What could be the issue. Will it be related to IOS. (hope this is t...
I have a CISCO 2620 router that connects to an Internet VPN, I also have two Adtran atlas 550 router that connect a frame relay network to the local network, the problem is when one of the Adtran routers is connect to the local network traffic slows...
HI,I want to devide e1 pri in two groups i.e 1mpbs each,while doing this i have a doubt about signalling channel 15, whts the right way of grouping,channel-group 0 timeslots 1-15channel-group 16 timeslots 16-31is this a right way or i have to exclude...
I have two cisco 1720 routers with 1 fastethernet interface each. I need to run HSRP, plus I need two different subnets. So I created secondary ip address.Config looks like this:Router_1: interface FastEthernet0 ip address 192.168.3.2 255.255.255.0 s...
