Other Network Architecture Subjects

How do i monitor realtime packet statistics specifically on a fastethernet port on the 3500XL Catalyst? Meaning you can actually see the number of packets increasing eg bad packets etc.

I'm trying to copy a .bin file, from my tftp server, to a 2924 switch in my network.I get the following error when trying to perform a "copy tftp flash"....copy to or from flash not implementedAny thoughts on this?? I've never seen this one before.T...

we have an ADSL service connecting into 2600 Router, the ADSL customers connecting through vpdn, so we have a Virtual-Template interface that contain the configuration of this ADSL service .and when each user connect to the router its virtual access ...

The sample configuration below was taken from Cisco website for a Cisco 827 router. Can I use this same configuration for a Cisco 828 (IOS Version 12.2(1)XE1) router for pure bridging?Cisco827 Pure Bridging Configuration: service timestamps debug ...

I have a 3640 Router with bootstrap vers 11.1 and IOS 12.1(5) and i must update the modemfirmware form a Firmware at 1998 ver2310-6/31998 to the Firmware c3600-2600-analog-fw.1.2.2.bin .In the Upgrate Doku is the notice copy with tftp the Firmware to...

Hello All,I am running Cisco Works for Windows 6.0 on Windows 98 machine (on a test basis).I have installed JRE 1.3 and the JREserver is running too.While opening Cisco View (from the browser of CWW) it gives me following error"Please Grant permissio...

Someone know how I must configure the RIP protocol to run this over a Dialer interface with the IP address negotiated.Thanks

I have created layer 3 VLAN's on a 3620 router with IOS (tm) 3600 Software (C3620-JS-M), Version 12.2(1), RELEASE SOFTWARE (fc2).For example:interface FastEthernet1/0.9 description Interface to LAN Subnet 10.210.2.0 encapsulation isl 709 ip address 1...

Looking for information that pretains to the Catalyst 4000 and at which code level ISL was first supported. Also, did this also require new switch hardware? I.E. SUP III card.

What is required on Cisco View (CiscoWorks 2000) to be able to actually show Dial Services or AAA information on an AS5300.Does CDP need to be enabled on a particular interface? We have the AAA Accounting information configured on the AS5300. When we...

I'm trying to use HSRP using a serial connection as the primary and an ISDN line as the secondary, i get it working but when the main line comes back up the ISDN won't hang up. Does anyone have a sample configuration using a 2621 as the primary and ...

Due to the increase in the number of users in our network, we have been asigned three different Class B subnets 148.244.56.160, 148.244.56.192 and 148.244.56.224 all with mask 255.255.255.224 and each one with 30 possible hosts.Is there any way to ha...

I have a 805 router that not supporting the IP Multicast routing. I have run through the documentation that mentioned 805 only able to support multicast relay. Anybodies who has the ideas about this ? I can't find a way for how to configuring the mul...

I am working on a problem that allows an FTP from a PIX 520 ver 4.4(5) transferring data from a 100 security interface to complete an FTP tranfer to another device through a 75 security interface - no problem with the transfer. When I do the revers ...

We're having problems fractionalizing a T-1 and I wanted to test the inside network to make sure everything is configuring and passing data. I'm looping up the inside, and wanted to know if the serial line protocol should come up.